Search results
Results from the WOW.Com Content Network
degrees and decimal minutes: 40° 26.767′ N 79° 58.933′ W; decimal degrees: +40.446 -79.982; There are 60 minutes in a degree and 60 seconds in a minute. Therefore, to convert from a degrees minutes seconds format to a decimal degrees format, one may use the formula
The Military Grid Reference System (MGRS) [1] is the geocoordinate standard used by NATO militaries for locating points on Earth. The MGRS is derived from the Universal Transverse Mercator (UTM) grid system and the Universal Polar Stereographic (UPS) grid system, but uses a different labeling convention.
Decimal degrees (DD) is a notation for expressing latitude and longitude geographic coordinates as decimal fractions of a degree. DD are used in many geographic information systems (GIS), web mapping applications such as OpenStreetMap , and GPS devices.
Under the Chairman of the Joint Chiefs of Staff Instruction CJCSI 3900.01C dated 30 June 2007, GARS was adopted for use by the US DoD as "the “area-centric” counterpart to the “point-centric” MGRS". It uses the WGS 1984 Datum and is based on lines of longitude (LONG) and latitude (LAT). It is intended to provide an integrated common ...
Grid Zone Designation (GZD); for a world-wide unique address. This consists of up to 2 digits (6-degree longitude UTM zone) for West to East, followed by a letter (8-degree latitude band) from South to North; in this example, "18S". [10] [11] 100,000-meter (100 km) Square Identification; for regional areas.
These letters form the third and fourth characters of a full GEOREF coordinate. Four letters thus identify any 1-degree quadrangle in the world. Each of the 1-degree quadrangles is further subdivided into 60 1-minute longitude zones, numbered 00 through 59 from west to east, and 60 1-minute latitude bands, numbered 00 to 59 from south to north.
The geographical coordinates are embedded in the email link which is then displayed. The coordinates are the two numbers displayed immediately after the letters "cp=". The latitude and longitude are separated by a tilde ( ~ ). The latitude is displayed first, and both coordinates are displayed in decimal degrees format. (in degrees only).
For example, in the Military Grid Reference System, the above coordinate is in grid 11U (representing UTM Zone 11 5xxxxxx mN), and grid cell NS within that (representing the second digit 5xxxxxmE x6xxxxxm N), and as many remaining digits as are needed are reported, yielding an MGRS grid reference of 11U NS 949 361 (or 11U NS 9493 3617 or 11U NS ...