Search results
Results from the WOW.Com Content Network
In rail transport, a wheel arrangement or wheel configuration is a system of classifying the way in which wheels are distributed under a locomotive. [1] Several notations exist to describe the wheel assemblies of a locomotive by type, position, and connections, with the adopted notations varying by country.
With this configuration, the cars have 6 wheels per assembly running on the main rails, and an additional 4 wheels per side running on the extra set of rails. On flying roller coasters , such as those produced by Bolliger & Mabillard and Vekoma , the running wheels and up-stop wheels are typically the same size due to the trains upright ...
The initial design of the GM 10.5" 14-bolt differential spanned from 1973 to 1984, remaining unaltered until 1986. This iteration featured brake drums secured by wheel studs and utilized a smaller diameter pinion bearing compared to the subsequent design. The second design, in production since 1986, introduced notable improvements.
An axlebox, also known as a journal box in North America, is the mechanical subassembly on each end of the axles under a railway wagon, coach or locomotive; it contains bearings and thus transfers the wagon, coach or locomotive weight to the wheels and rails; the bearing design is typically oil-bathed plain bearings on older rolling stock, or roller bearings on newer rolling stock.
The AAR wheel arrangement system is a method of classifying locomotive (or unit) wheel arrangements that was developed by the Association of American Railroads.Essentially a simplification of the European UIC classification, it is widely used in North America to describe diesel and electric locomotives (including third-rail electric locomotives).
The hub assembly is located between the brake drums or discs and the drive axle. A wheel is bolted on it. Depending on the construction, the end of the hub comes equipped with the splined teeth. They mate the teeth on the axle shaft. The axle hub spins along with the wheels bolted to it and provide power to the wheels in order to rotate.
Wheel track, track width or simply track refers to the distance between the centerline of two wheels on the same axle. In the case of an axle with dual wheels, the centerline of the dual wheel assembly is used for the wheel track specification. Axle and wheel track are commonly measured in millimetres or inches. [2] [3]
A round plate with a hole in its centre is located on the underside of the wagon. The plate on the wagon, in turn, sits on the plate on the axle between the wheels. This arrangement allows the axle and wheels to turn horizontally. The pin and hole arrangement could be reversed. The horse harness is attached to this assembly