Ads
related to: what is stall in aviation school
Search results
Results from the WOW.Com Content Network
According to Federal Aviation Administration (FAA) terminology, the above example illustrates a so-called turning flight stall, while the term accelerated is used to indicate an accelerated turning stall only, that is, a turning flight stall where the airspeed decreases at a given rate.
Accidents, such as the 1963 BAC One-Eleven test crash, were attributable to aerodynamic stalls and motivated aviation regulatory bodies to establish requirements for certain aircraft to be outfitted with stall protection measures, such as the stick shaker and stick pusher, to reduce such occurrences. While the stick shaker has become relatively ...
A shock stall is a stall created when the airflow over an aircraft's wings is disturbed by shock waves formed when flying at or above the aircraft's drag divergence Mach number. Shock stall may cause control problem during speed transition (transonic to supersonic). Thin supercritical wing section and swept-back wing can postpone shock stall to ...
Wingtip stall is unlikely to occur symmetrically, especially if the aircraft is maneuvering. As an aircraft turns, the wing tip on the inside of the turn is moving more slowly and is most likely to stall. As an aircraft rolls, the descending wing tip is at higher angle of attack and is most likely to stall.
The airspeed at which the aircraft stalls varies with the weight of the aircraft, the load factor, the center of gravity of the aircraft and other factors. However, the aircraft normally stalls at the same critical angle of attack, unless icing conditions prevail. The critical or stalling angle of attack is typically around 15° - 18° for many ...
The minimum such speed is the stall speed, or V SO. The indicated airspeed at which a fixed-wing aircraft stalls varies with the weight of the aircraft but does not vary significantly with altitude. At speeds close to the stall speed the aircraft's wings are at a high angle of attack. At higher altitudes, the air density is lower than at sea level.
The falling leaf is often used as a training maneuver, teaching the pilot to control the plane during a stall and helping beginners to overcome the fear that happens when a plane stalls unexpectedly. It is generally performed from a low-speed, straight, level stall, to avoid the buffeting, departure from the normal flightpath, and flat spin ...
One of a pair of stall strips installed on an American Aviation AA-1 Yankee during manufacture. A stall strip is a small component fixed to the leading edge of the wing of an airplane to modify its aerodynamic characteristics. [1] These stall strips may be necessary for the airplane to comply with type certification requirements.
Ads
related to: what is stall in aviation school