Search results
Results from the WOW.Com Content Network
Note: Use of this table for estimating bullet masses for historical large-bore rifles is limited, as this table assumes the use of round ball, rather than conical bullets; for example, a typical 4-bore rifle from circa 1880 used a 2,000-grain (4.57 oz; 129.60 g) bullet, or sometimes slightly heavier, rather than using a 4-ounce (110 g) round ...
The name, derived from an old English practice of bore measurements in gun-making which refers to a nominally 4-gauge bore, that is, a bore diameter that would accommodate a pure lead round ball weighing 1 ⁄ 4 of a pound. This would imply a bore diameter of 1.052-inch (26.7 mm), however in practice the bore diameter varied greatly as, in ...
While shotgun bores can be expressed in calibers (the .410 bore shotgun is measured as .410 in (10.4 mm) in diameter, [12] unlike with rifles the actual bore diameter of a smoothbore shotgun varies significantly down the length of the barrel, with the use of chokes and back-boring.
The French scale measures the outer diameter of the catheter, not the size of the internal drainage channel (inner diameter). For instance, a two-way catheter of 20 Fr and a three-way catheter of 20 Fr have the same outer diameter, but the three-way catheter has an additional channel for irrigation, reducing the size of its drainage channel.
Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.
In a piston engine, the bore (or cylinder bore) is the diameter of each cylinder. Engine displacement is calculated based on bore, stroke length and the number of cylinders: [ 1 ] displacement = π ( 1 / 2 × bore ) 2 × stroke × n cylinders
The hydraulic diameter, D H, is a commonly used term when handling flow in non-circular tubes and channels. Using this term, one can calculate many things in the same way as for a round tube. When the cross-section is uniform along the tube or channel length, it is defined as [1] [2] =, where
The limit to bore diameter is generally the sectional density of the projectile (see external ballistics). Larger-diameter bullets of the same weight have much more drag, and so they lose energy more quickly after exiting the barrel. In general, most handguns use bullets between .355 (9 mm) and .45 (11.5 mm) caliber, while most rifles generally ...