Search results
Results from the WOW.Com Content Network
A steam separator, sometimes referred to as a moisture separator or steam drier, is a device for separating water droplets from steam. The simplest type of steam separator is the steam dome on a steam locomotive. Stationary boilers and nuclear reactors may have more complex devices which impart a "spin" to the steam so that water droplets are ...
A steam drum is a standard feature of a water-tube boiler. It is a reservoir of water/steam at the top end of the water tubes. The drum stores the steam generated in the water tubes and acts as a phase-separator for the steam/water mixture. The difference in densities between hot and cold water helps in the accumulation of the "hotter"-water ...
Cutaway section of a steam dome, showing the regulator inside. The steam dome is a vessel fitted to the top of the boiler of a steam engine.It contains the opening to the main steam pipe and its purpose is to allow this opening to be kept well above the water level in the boiler.
A steam generator is a form of low water-content boiler, similar to a flash steam boiler. The usual construction is as a spiral coil of water-tube , arranged as a single, or monotube , coil. Circulation is once-through and pumped under pressure, as a forced-circulation boiler . [ 1 ]
Frequently, steam, air, inert gases, and hydrocarbon gases are used as stripping agents. This is based on solubility, stability, degree of corrosiveness, cost, and availability. As stripping agents are gases, operation at nearly the highest temperature and lowest pressure that will maintain the components and not vaporize the liquid feed stream ...
From the waterwalls, the water/steam mixture enters the steam drum and passes through a series of steam and water separators and then dryers inside the steam drum. The steam separators and dryers remove water droplets from the steam; liquid water carried over into the turbine can produce destructive erosion of the turbine blades. and the cycle ...
To combat this, after exiting the steam generator, the mixture is put through a centrifugal steam separator which does exactly that producing steam that is above ninety-nine percent dry saturated steam. [4] If superheated steam is desired, an additional coil is run back through the steam generator. To maintain a constant level of water in the ...
From Brown Boveri Review [3]. The Velox principle combines the use of combustion under pressure, with very high flue gas velocities and with a gas turbine, whereby the pressure in the combustion chamber, the high gas velocities and the pressure drop of the gases for production of work are created by means of a compressor driven by the gas turbine, the latter being actuated by the products of ...