Search results
Results from the WOW.Com Content Network
A start-stop system off button on a Perodua Myvi. A vehicle start-stop system or stop-start system (also known as S&S, micro hybrid, or micro hybrid electric vehicle (μHEV)) [1] automatically shuts down and restarts the internal combustion engine to reduce the amount of time the engine spends idling, thereby reducing fuel consumption and emissions.
If the car's own vapor recovery system is working properly, then the Stage II nozzle will only be vacuuming normal fresh air and depositing that into the gas station's underground fuel storage tanks. That ends up causing evaporation of fuel vapors into the atmosphere, because too much pressure builds up in those fuel storage tanks.
In motorcycles and cars, the fuel reserve setting indicates that the level of fuel in the tank is low. In cars and most modern motorcycles this quantity (the reserve) is automatically available. Older motorcycles have a manual fuel tap or petcock. When the main fuel is exhausted, the motor will start sputtering, prompting the rider to change ...
Studies show that rapid accelerations and hard braking consume up to 40% more gas in stop-and-go traffic, and up to 30% more on the highway. ... "start the engine and then drive the car normally ...
To do a burnout in a manual transmission vehicle, you first start in neutral, then you press and hold the clutch, shift into first gear, floor the gas, and finally dump the clutch and quickly move your foot onto the brake pedal to hold the brakes. After this you can then release off the brakes to peel out or you can stand on it.
For premium support please call: 800-290-4726 more ways to reach us
Pumping the brakes" is strongly discouraged during an unintended acceleration event, as this can lead to a loss of braking power. [74] It is also strongly recommended not to shut off the engine, which disables all control including the steering wheel. [75] Unresponsive (entrapped) pedals can be avoided by using car mat clips. [76]
Once set, the driver must keep the clutch pedal fully depressed but may remove the foot from the brake pedal. To disengage the system and move the car forward, the driver selects first gear, gently depresses the gas pedal, and slowly releases the clutch pedal which at a point in its travel releases the braking system, allowing the car to proceed.