Search results
Results from the WOW.Com Content Network
MCA-Jet was a simpler system that sent the same air/fuel mixture to all intake and MCA-Jet valves. Each MCA-Jet valve is quite small and may be prone to carbon build-up, causing the MCA-Jet valve(s) to stick open. If a Mitsubishi-designed engine has low compression, the MCA-Jet valve(s) could be the cause.
In double overhead camshaft (DOHC) designs, the air paths may sometimes be connected to separate intake valves [citation needed] so the shorter path can be excluded by de-activating the intake valve itself. Pressurisation A tuned intake path can have a light pressurising effect similar to a low-pressure supercharger due to Helmholtz resonance ...
The low-lift cams and rocker arms - which drive separate intake valves - are positioned on either side of a centrally located high-lift cam. Each of the intake valves is operated by a low-lift cam and rocker arm, while placing a T-lever between them allows the valves to follow the action of the high-lift cam. [8]
Carburetors used as intake runners A cutaway view of the intake of the original Fordson tractor (including the intake manifold, vaporizer, carburetor, and fuel lines). An inlet manifold or intake manifold (in American English) is the part of an internal combustion engine that supplies the fuel/air mixture to the cylinders. [1]
A valvetrain is a mechanical system that controls the operation of the intake and exhaust valves in an internal combustion engine. [1] The intake valves control the flow of air/fuel mixture (or air alone for direct-injected engines) into the combustion chamber, while the exhaust valves control the flow of spent exhaust gases out of the ...
The older flathead engine design uses a "bathtub"-shaped combustion chamber, with an elongated shape that sits above both the piston and the valves (which are located beside the piston). IOE engines combine elements of overhead valve and flathead engines; the intake valve is located above the combustion chamber, while the exhaust valve is ...
Intake manifold vacuum is applied to the crankcase via the PCV valve. The airflow through the crankcase and engine interior sweeps away combustion byproduct gases. This mixture of air and crankcase gases then exits, often via another simple baffle, screen, or mesh to exclude oil mist, through the PCV valve and into the intake manifold. On some ...
Swirl flap principle in a four-valve engine. A swirl flap is a small butterfly valve fitted to four-stroke internal combustion engines with at least two intake valves.It is installed inside or just before one of a cylinder's two intake ports, allowing to throttle its intake port's air flow, causing a swirl in the other intake port not fitted with a swirl flap.