Ad
related to: logic probe vs multimeter batteryzoro.com has been visited by 100K+ users in the past month
Average: 4.7 out of 5 - 83,309 reviews - Power Reviews
Search results
Results from the WOW.Com Content Network
A control on the logic probe allows either the capture and storage of a single event or continuous running. When the logic probe is either connected to an invalid logic level (a fault condition or a tri-stated output) or not connected at all, none of the LEDs light up. Another control on the logic probe allow selection of either TTL or CMOS ...
A multimeter with a built in clamp facility. Pushing the large button at the bottom opens the lower jaw of the clamp, allowing the clamp to be placed around a conductor (wire). Depending on sensor, some can measure both AC and DC current. RF probe; Signal tracer
A test probe is a physical device used to connect electronic test equipment to a device under test (DUT). Test probes range from very simple, robust devices to complex probes that are sophisticated, expensive, and fragile. Specific types include test prods, oscilloscope probes and current probes.
Analog multimeter Digital multimeter. A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [2] [3] A typical multimeter can measure voltage, resistance, and current, [4] in which case can be used as a voltmeter, ohmmeter, and ammeter.
A SMU integrates a highly stable DC power source, as a constant current source or as a constant voltage source, and a high precision multimeter. It typically has four terminals, two for source and measurement and two more for kelvin, or remote sense, connection. Power is simultaneously sourced (positive) or sinked (negative) to a pair of ...
Logic analyzer. A logic analyzer is an electronic instrument that captures and displays multiple logic signals from a digital system or digital circuit. A logic analyzer may convert the captured data into timing diagrams, protocol decodes, state machine traces, opcodes, or may correlate opcodes with source-level software. Logic analyzers have ...
In electronics, a continuity test is the checking of an electric circuit to see if current flows (that it is in fact a complete circuit). A continuity test is performed by placing a small voltage (wired in series with an LED or noise-producing component such as a piezoelectric speaker) across the chosen path.
The 7D11 ($2,915 in 1983) was a digital delay, the 7D15 ($3,020) was a 225 MHz counter/timer, the 7D13 ($1,105) was a multimeter, and the 7D12/M2 ($2,815) was a sample-and-hold with an analog-to-digital converter. More exotic digital plug ins used the mainframe oscilloscope as a mere display unit. The 7D01 and 7D02 were logic analyzer plug ins.
Ad
related to: logic probe vs multimeter batteryzoro.com has been visited by 100K+ users in the past month
Average: 4.7 out of 5 - 83,309 reviews - Power Reviews