enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Parallel (engineering) - Wikipedia

   en.wikipedia.org/wiki/Parallel_(engineering)

   Parallels supporting a vee block and a workpiece. A parallel is a rectangular block of metal, commonly made from tool steel, stainless steel or cast iron, which has 2, [1] 4 or 6 faces ground or lapped to a precise surface finish.

3. Angle plate - Wikipedia

   en.wikipedia.org/wiki/Angle_plate

   An angle plate is a work holding device used as a fixture in metalworking. Angle plates are used to hold workpieces square to the table during marking out operations. Adjustable angle plates are also available for workpieces that need to be inclined, usually towards a milling cutter .

4. Milling (machining) - Wikipedia

   en.wikipedia.org/wiki/Milling_(machining)

   Vertical milling machine. 1: milling cutter 2: spindle 3: top slide or overarm 4: column 5: table 6: Y-axis slide 7: knee 8: base. In the vertical milling machine the spindle axis is vertically oriented. Milling cutters are held in the spindle and rotate on its axis. The spindle can generally be lowered (or the table can be raised, giving the ...

5. V-block - Wikipedia

   en.wikipedia.org/wiki/V-block

   V-Blocks are precision metalworking jigs typically used to hold round metal rods or pipes for performing drilling or milling operations. They consist of a rectangular steel or cast iron block with a 120 degree channel rotated 45-degrees from the sides, forming a V-shaped channel in the top. A small groove is cut in the bottom of the "V".

6. Sine bar - Wikipedia

   en.wikipedia.org/wiki/Sine_bar

   Angles are measured using a sine bar with the help of gauge blocks and a dial gauge or a spirit level. The aim of a measurement is to measure the surface on which the dial gauge or spirit level is placed horizontally. For example, to measure the angle of a wedge, the wedge is placed on a horizontal table. The sine bar is placed over the ...

7. Rotary table - Wikipedia

   en.wikipedia.org/wiki/Rotary_table

   Rotary tables are most commonly mounted "flat", with the table rotating around a vertical axis, in the same plane as the cutter of a vertical milling machine.An alternate setup is to mount the rotary table on its end (or mount it "flat" on a 90° angle plate), so that it rotates about a horizontal axis.