Ads
related to: pine tongue and groove boards over 16 feet
Search results
Results from the WOW.Com Content Network
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles
The beams are spaced 4 feet (1.2 m) to 18 feet (5.5 m) apart and the planks are 2 inches (5.1 cm) or more thick possibly with another layer of 1 inch (2.5 cm) on the top as the finished flooring could span these distances. The planks may be laid flat and tongue and grooved or splined together or laid on edge called a laminated floor. [24]
In 1876 David Ewart, General Inspector for the Department of Public Instruction, described the Waterford school building as measuring 30 by 16 feet (9.1 by 4.9 m), with an entrance porch and no verandahs. It had exterior ironbark studs, pine tongue and groove walls, pine floor boards, and a hardwood shingled roof.
The main interior staircase is composed of three flights in a square 'U' shape and is finished in oak handrails supported by gothic arch balusters. Upper and lower flooring is 1-inch (25 mm) blind-nailed hard pine tongue and groove. Hard pine steps make up the stairs. The building holds approximately 5,500 square feet (510 m 2) of floor space ...
It was a lowset timber building with outside studding. It faced east with a verandah on the east and west sides and accommodated one large room 30 by 16 feet (9.1 m × 4.9 m). The gable roof was clad with hardwood timber shingles and the interior was lined with pine tongue-and-groove timber boards. [19]
The more commonly used boards in New England are vertical-grain boards. Depending on the diameter of the log, cuts are made from 4 + 1 ⁄ 2 to 6 + 1 ⁄ 2 inches (110 to 170 mm) deep along the full length of the log. Each time the log turns for the next cut, it is rotated 5 ⁄ 8 inch (16 mm) until it has turned 360°. This gives the radially ...
Tongue-and-groove: One side and one end of the plank have a groove, the other side and end have a tongue (protruding wood along an edge's center). The tongue and groove fit snugly together, thus joining or aligning the planks, and are not visible once joined. Tongue-and-groove flooring can be installed by glue-down (both engineered and solid ...
Matchboard by definition is "a board with a groove cut along one edge and a tongue along the other so as to fit snugly with the edges of similarly cut boards." [1]Bramble Cottage on Lundy Island, weathered cedar matchboarding in an exposed location
Ads
related to: pine tongue and groove boards over 16 feet