enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bead breaker - Wikipedia

   en.wikipedia.org/wiki/Bead_breaker

   A tire bead is held in the groove by air pressure. A bead breaker is a tool used for separating tires from rims. The innermost diameter of the tire that interfaces with the rim of a wheel is called the tire bead. The bead is a thicker section of rubber, and is reinforced with braided steel cables, called the bead bundle. [1]

3. Tire changer - Wikipedia

   en.wikipedia.org/wiki/Tire_changer

   The bead loosening system releases the tire bead from the rim of the wheel. The bead loosening system consists of an arm near the bottom right side of the tire changer. There is a shovel shaped metal piece at the end of the arm called the bead loosener shoe. The bead loosener shoe pivots and is rounded to accommodate the shape of a wheel.

4. Beadlock - Wikipedia

   en.wikipedia.org/wiki/Beadlock

   A standard beadlock is designed to clamp the tire bead between an outer and an inner ring. The inner ring may be welded onto a standard wheel increasing wheel width by anywhere from 1 + 1 ⁄ 2 to 2 inches (3.8 to 5.1 cm) or may be formed as part of the wheel when the wheel is made in the factory. The outer ring is then bolted onto the inner ...

5. Tire bead - Wikipedia

   en.wikipedia.org/wiki/Tire_bead

   Tire bead is the term for the edge of a tire that sits on the rim. Wheels for automobiles, bicycles, etc. are made with a small slot or groove into which the tire bead sits. When the tire is properly inflated, the air pressure within the tire keeps the bead in this groove. Reducing tire air pressure is a frequent practice among off-road vehicle ...

6. Radial tire - Wikipedia

   en.wikipedia.org/wiki/Radial_tire

   The green (uncured) tire was loaded over a curing bladder and shaped into the mold. This shaping process caused the cords in the tire to assume an S-shape from bead to bead. The angle under the tread, the crown angle, stretched down to about 36 degrees. In the sidewall region the angle was 45 degrees, and in the bead it remained at 60 degrees.

7. Tire maintenance - Wikipedia

   en.wikipedia.org/wiki/Tire_maintenance

   Tire maintenance for motor vehicles is based on several factors. The chief reason for tire replacement is friction from moving contact with road surfaces, causing the tread on the outer perimeter of tires to eventually wear away. When the tread depth becomes too shallow, like for example below 3.2 mm (4/32 in), the tire is worn out and should ...