enow.com Web Search

  1. Ads

    related to: centrifugal pump impeller drawing

Search results

  1. Results from the WOW.Com Content Network
  2. Centrifugal pump - Wikipedia

    en.wikipedia.org/wiki/Centrifugal_pump

    If the pump casing becomes filled with vapors or gases, the pump impeller becomes gas-bound and incapable of pumping. [10] To ensure that a centrifugal pump remains primed and does not become gas-bound, most centrifugal pumps are located below the level of the source from which the pump is to take its suction.

  3. Impeller - Wikipedia

    en.wikipedia.org/wiki/Impeller

    Several different types of pump impellers Flexible impeller of cooling system pump of an outboard engine (1 euro cent coin for comparison, diameter 16.25 mm). An impeller is a rotating component of a centrifugal pump that accelerates fluid outward from the center of rotation, thus transferring energy from the motor that drives the pump to the fluid being pumped.

  4. Centrifugal compressor - Wikipedia

    en.wikipedia.org/wiki/Centrifugal_compressor

    The simplest inlet to a centrifugal compressor is typically a simple pipe. Depending upon its use/application inlets can be very complex. They may include other components such as an inlet throttle valve, a shrouded port, an annular duct (see Figure 1.1), a bifurcated duct, stationary guide vanes/airfoils used to straight or swirl flow (see Figure 1.1), movable guide vanes (used to vary pre ...

  5. File:Open Type Centrifugal Pump Impeller.ogv - Wikipedia

    en.wikipedia.org/wiki/File:Open_Type_Centrifugal...

    Open_Type_Centrifugal_Pump_Impeller.ogv (Ogg multiplexed audio/video file, Theora/Vorbis, length 1 min 24 s, 320 × 240 pixels, 721 kbps overall, file size: 7.19 MB) This is a file from the Wikimedia Commons .

  6. Piping and instrumentation diagram - Wikipedia

    en.wikipedia.org/wiki/Piping_and_instrumentation...

    In the process industry, a standard set of symbols is used to prepare drawings of processes. The instrument symbols used in these drawings are generally based on International Society of Automation (ISA) Standard S5.1; The primary schematic drawing used for laying out a process control installation. They usually contain the following information:

  7. Net positive suction head - Wikipedia

    en.wikipedia.org/wiki/Net_positive_suction_head

    Example: A pump with a max. pressure head of 8 bar (80 metres) will actually run at 18 bar if the NPSH A is 10 bar. i.e.: 8 bar (pump curve) plus 10 bar NPSH A = 18 bar. This phenomenon is what manufacturers use when they design multistage pumps, (Pumps with more than one impeller). Each multi stacked impeller boosts the succeeding impeller to ...

  1. Ads

    related to: centrifugal pump impeller drawing