Search results
Results from the WOW.Com Content Network
Simple CVTs combining a centrifugal drive pulley with a spring-loaded driven pulley often use belt tension to effect the conforming adjustments in the driven pulley. [3] The V-belt needs to be very stiff in the pulley's axial direction to make only short radial movements while sliding in and out of the pulleys. The radial thickness of the belt ...
This is an accepted version of this page This is the latest accepted revision, reviewed on 20 January 2025. Mechanical device that connects and disconnects two rotating shafts or other moving parts For other uses, see Clutch (disambiguation). Friction disk for a dry clutch A clutch is a mechanical device that allows an output shaft to be disconnected from a rotating input shaft. The clutch's ...
The Comet J11 was manufactured from 1954 to 1955. Engine: Villiers Mk 4F (98cc) (47mm x 57mm), Carburetor was a Villiers Type 6/0; Transmission: Two speed with clutch. Frame: Single down tube; Suspension: Front was lightweight telescopic fork, plastic gaiters. Rear was a plunger-type. Brakes: 4" front, 5" rear; Drive: Chain and sprocket
The open belt drive has parallel shafts rotating in the same direction, whereas the cross-belt drive also bears parallel shafts but rotate in opposite direction. The former is far more common, and the latter not appropriate for timing and standard V-belts unless there is a twist between each pulley so that the pulleys only contact the same belt ...
Ixion engine on a Komet motorised bicycle, ca. 1902. This system is used, for example, to drive the spools in some tape recorders.In a typical configuration, one of the cylinders is the axle of an electric motor, say 1 mm in diameter, while the other is a disk with a hard rubber rim, say 50 mm in diameter, yielding a 1:50 mechanical advantage.
The one unique feature of Comet V cab cars, compared to earlier Comets and especially the Comet IV, is the lack of steps and a trapdoor at the door in the vestibule opposite the engineer's operating position. Therefore, it can only be used for high-platform boarding. Like the Comet IV, the engineer's side of the cab vestibule has no door.
1963 Leyland Comet (LAD) In 1958, as part of an effectivization program, the Comet received a new cab – called the "Vista Vue" cab, it was developed by Albion for a variety of their models. Dodge UK also used it for their 300 model, consequently this cabin shape is often referred to as the "LAD" design. There was also a heavier duty "Super ...
It is marketed variously under the trade names TCT - Twin Clutch Transmission , Euro Twin Clutch Transmission , [2] TCSS - The Twin Clutch System [3] and Dual-Dry-Clutch Auto Transmission . Able to receive torque inputs of up to 350 N⋅m (260 lbf⋅ft), the transmission is the highest-torque transverse dual-dry-clutch application.(2012) [ 4 ...