Search results
Results from the WOW.Com Content Network
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
The hot film MAF sensor works somewhat similar to the hot wire MAF sensor, but instead it usually outputs a frequency signal. This sensor uses a hot film-grid instead of a hot wire. [3] It is commonly found in late 1980s and early 1990s fuel-injected vehicles. The output frequency is directly proportional to the air mass entering the engine.
Because the value from a given sensor is always stored at the same location in RAM, these sensor values can be read if the memory location is known. The 14CUX is capable of storing diagnostic trouble codes in a 32-byte segment of its internal memory that is maintained (even while vehicle ignition is off) by applying 5VDC ( regulated down from ...
hot-wire mass air flow (MAF) sensor, cast aluminium alloy intake manifold, Garrett, KKK or BorgWarner variable turbine geometry turbocharger (VTG), side-mounted intercooler (SMIC), water-cooled exhaust gas recirculation (EGR), cast iron exhaust manifold fuel system & engine management
A fuel-injected engine may alternatively use a mass airflow sensor (MAF sensor) to detect the intake airflow. A typical naturally aspirated engine configuration employs one or the other, whereas forced induction engines typically use both; a MAF sensor on the Cold Air Intake leading to the turbo and a MAP sensor on the intake tract post- turbo ...
By using a blow-through method, the MAF won't be affected by the blowoff valve opening, since the pressure is vented before the air reaches the MAF. Other solutions include using a blowoff valve that recirculates the air back into the intake or using a manifold absolute pressure sensor (instead of an airflow sensor) to determine the amount of ...
What made this ECU special was the use of two crank sensors and one cam sensor. The ECU used one crank sensor to count the teeth on the starter ring for its RPM signal, and the other read a pin on the back of the flywheel for TDC reference. This ECU was first seen when the 20V turbo 5-cylinder engine (RR Code) was installed into the Audi Quattro.
A Digifant II DF-1 Engine Control Unit used in '91 Volkswagen Golf Cabriolet with 2E engine. Digifant is an Engine Management System operated by an Engine Control Unit that actuates outputs, such as fuel injection and ignition systems, using information derived from sensor inputs, such as engine speed, exhaust oxygen and intake air flow. [1]