Search results
Results from the WOW.Com Content Network
The clutch brake not only slows or stops the idle gear axis but can also prevent shifting into gear until the clutch pedal is released a few centimetres (or inches) off the floor. In order to shift into gear, the clutch must be halfway off the floor, otherwise, the clutch brake will prevent the transmission from being shifted into or out of gear.
In the US it is commonly called a brake booster. A vacuum servo, also known as a power booster or power brake unit, uses a vacuum, usually supplied by the engine, to multiply the driver's pedal effort and apply that effort to the master cylinder .
A dual-clutch transmission (DCT, sometimes referred to as a twin-clutch transmission, or double-clutch transmission) uses two separate clutches for odd and even gear sets. [36] The design is often similar to two separate manual transmissions with their respective clutches contained within one housing, and working as one unit.
If the transmission control unit senses a critical fault during driving, it will activate an emergency operating mode: Upon hydraulic failures, it will stop shifting gears and permanently retain the currently selected gear; if the failure can be pinpointed to one of the internal hydraulic control valves, the transmission will continue shifting but stop using the affected gear(s).
Vacuum boosters provide brake assist for the driver by multiplying the force out of the booster creating more than the force that was used to push on the brake pedal. The booster works by pulling the air out of the booster chamber with a pump or other vacuum source (typically the engine's intake manifold [1]), creating a low-pressure system ...
Clutch control is the controlling of the speed of a manual transmission vehicle by partially engaging the clutch plate, using the clutch pedal instead of (or in conjunction with) the accelerator pedal. The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts spinning at ...
The transmission brake is the yellow drum, to the right rear of the transfer box. A transmission brake or driveline parking brake is an inboard vehicle brake that is applied to the drivetrain rather than to the wheels. Historically, some early cars used transmission brakes as the normal driving brake and often had wheel brakes on only one axle ...
The standard Fluid Drive configuration consisted of the fluid coupling and a manual transmission and clutch in tandem. If the Fluid Drive was mated to a manual transmission, the driver still needed to use the clutch to shift between any of the gears. The presence of Fluid Drive, however, prevented the driver stalling when taking off from a dead ...