Search results
Results from the WOW.Com Content Network
Components on a concrete masonry unit and brick cavity wall. A cavity wall is composed of two masonry walls separated by an air space. The outer wall is made of brick and faces the outside of the building structure. [6] The inner wall may be constructed of masonry units such as concrete block, structural clay, brick or reinforced concrete. [6]
In a masonry cavity wall, there is usually a DPC in both the outer and inner wall. [8] In the outer wall it is normally 150 millimetres (5.9 in) to 200 mm (7.9 in) above ground level (the height of 2-3 brick courses). This allows rain to form puddles and splash up off the ground, without saturating the wall above DPC level.
The Template:Brick_chart/Bricks draws bricks for {{Brick chart}}. The bricks are displayed as 1, 2 or 3 bar line segments, depending on the offset and count numbers. Parameters: count - the number (or decimal) to represent by bar line segments; offset - the sum of prior count numbers (can be: 2+5+7.8, etc.)
A brickworks, also known as a brick factory, is a factory for the manufacturing of bricks, from clay or shale. Usually a brickworks is located on a clay bedrock (the most common material from which bricks are made), often with a quarry for clay on site.
A stepped gable, crow-stepped gable, or corbie step [1] is a stairstep type of design at the top of the triangular gable-end of a building. [ 1 ] [ 2 ] The top of the parapet wall projects above the roofline and the top of the brick or stone wall is stacked in a step pattern above the roof as a decoration and as a convenient way to finish the ...
A brick-built electrical substation in Birmingham, England, with a soldier course running the width of the building, immediately above the door Masonry coursing can be arranged in various orientations, according to which side of the masonry unit is facing the outside and how it is positioned.
The template can format a brick chart within 1/6 second, so 3 brick charts could appear within a page and add only 1/2 second to reformat, or edit-preview. The initial creation of the template occurred in August 2009; however, the alignment for display problems with overlapped bars was fixed in September 2012, over 3 years later.
A "face brick" is a higher-quality brick, designed for use in visible external surfaces in face-work, as opposed to a "filler brick" for internal parts of the wall, or where the surface is to be covered with stucco or a similar coating, or where the filler bricks will be concealed by other bricks (in structures more than two bricks thick).