Search results
Results from the WOW.Com Content Network
A through [1] dado involves cuts which run between both edges of the surface, leaving both ends open. A stopped or blind [2] dado ends before one (stopped) or both (blind) of the cuts meets the edge of the surface. [1] A half dado is formed with a narrow dado cut into one part, coupled with a rabbet of another piece. This joint tends to be used ...
Cisco VIP 2-40, from an older generation of routers. Performance Route Processor, from the high-end Cisco 12000 series.. In routing, the data plane, sometimes called the forwarding plane or user plane, defines the part of the router architecture that decides what to do with packets arriving on an inbound interface.
Dado joint: Also called a housing joint or trench joint, a slot is cut across the grain in one piece for another piece to sit in; shelves on a bookshelf having slots cut into the sides of the shelf, for example. Groove joint: Like the dado joint, except that the slot is cut with the grain. Sometimes referred to interchangeably with the dado joint.
It allows a device on a network to ask the router to open a port. Interactive Connectivity Establishment (ICE) is a complete protocol for using STUN and/or TURN to do NAT traversal while picking the best network route available. It fills in some of the missing pieces and deficiencies that were not mentioned by STUN specification.
Two video matrix units in a rack. A video router, also known as a video matrix switch or SDI router, is an electronic switch designed to route video signals from multiple input sources such as cameras, VT/DDR, computers and DVD players, to one or more display devices, such as monitors, projectors, and TVs.
If a packet is sent to 203.0.113.1 by a computer at 192.168.1.100, the packet would normally be routed to the default gateway (the router) [e] A router with the NAT loopback feature detects that 203.0.113.1 is the address of its WAN interface, and treats the packet as if coming from that interface. It determines the destination for that packet ...
In the seven-layer OSI model of computer networking, packet strictly refers to a protocol data unit at layer 3, the network layer. [2] A data unit at layer 2, the data link layer, is a frame.
Data transmitted may be digital messages originating from a data source, for example a computer or a keyboard. It may also be an analog signal such as a phone call or a video signal, digitized into a bit-stream for example using pulse-code modulation (PCM) or more advanced source coding (analog-to-digital conversion and data compression) schemes.