enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fuse cutout - Wikipedia

   en.wikipedia.org/wiki/Fuse_cutout

   In electrical distribution, a fuse cutout or cut-out fuse (often referred to as a cutout) is a combination of a fuse and a switch, used in primary overhead feeder lines and taps to protect distribution transformers from current surges and overloads. An overcurrent caused by a fault in the transformer or customer circuit will cause the fuse to ...

3. Box joint - Wikipedia

   en.wikipedia.org/wiki/Box_joint

   Box joint. A box joint is a woodworking joint made by cutting a set of complementary, interlocking profiles in two pieces of wood, which are then joined (usually) at right angles, usually glued. The glued box joint has a high glued surface area resulting in a strong bond, on a similar principle to a finger joint. Box joints are used for corners ...

4. Distribution board - Wikipedia

   en.wikipedia.org/wiki/Distribution_board

   A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.

5. Router table (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_table_(woodworking)

   The machine normally features a vertical fence, against which the workpiece is guided to control the horizontal depth of cut. Router tables are used to increase the versatility of a hand-held router, as each method of use is particularly suited to specific application, e.g. very large workpieces would be too large to support on a router table ...

6. Router (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_(woodworking)

   View underneath a router table showing plunge router attached. A router may be mounted upside down in a router table or bench. The router's base plate is mounted to the underside of the table, with a hole allowing the bit to protrude above the table top. This allows the work to be passed over the router, rather than passing the router over the ...

7. Edge jointing - Wikipedia

   en.wikipedia.org/wiki/Edge_jointing

   Normally, the desired outcome of jointing is an edge which is straight along its length and perpendicular to the face of the board. However, there is another technique often used when gluing up panels, referred to as a sprung joint. [1] In this technique, the desired outcome is an edge which is slightly concave along its length.

8. Groove (joinery) - Wikipedia

   en.wikipedia.org/wiki/Groove_(joinery)

   A groove can be cut by the following methods: electric router using a straight or rebate bit; circular saw with multiple passes (depending on width and depth) dado set in a single pass; spindle moulder (wood shaper) hand saw and chisel; router plane; grooving plane

9. Joinery - Wikipedia

   en.wikipedia.org/wiki/Joinery

   Butt joint: The end of a piece of wood is butted against another piece of wood. This is the simplest and weakest joint. Of those, there is the a) T-butt, b) end-to-end butt, c) Miter butt and d) edge-to-edge butt. Lap joint: The end of a piece of wood is laid over and connected to another piece of wood.