Search results
Results from the WOW.Com Content Network
If you're using broadband (cable) internet and you can't connect, try the following troubleshooting steps in the order listed until you get up and running again. 1. Check if you can visit other sites with a different browser - If you can go to another site, the problem may be associated the browser you're using.
That event returns the modem back into command mode. Unlike in standard dial-up data mode, dropping DTR isn't an appropriate way to resume command mode since a hangup is not desired, and an escape code with mandatory pauses isn't suitable either. Because of this, literal 0x10 bytes in data are doubled from the computer to the modem as well.
Desktop Gold doesn't provide dial-up internet connectivity and can only be used if you already have a broadband internet connection. If you're having trouble getting online, check to see if the issue is with your internet connection.Our help article, Troubleshooting a Broadband Connection , provides some useful troubleshooting tips.
For example, during playback of an 8 kHz audio file at 8-bit resolution (which creates 8,000 bytes, or 80,000 bits when including start/stop bits, per second), the data must travel over the serial port at a minimum of 115,200 bits per second. (115,200 bit/s is the first setting of a typical computer serial port that's greater than 80,000.)
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
According to the RS232 standard, dropping DTR from active to inactive for at least two seconds tells the modem to disconnect (end) a call or data connection. When a modem is being used for automatic answering (such as with the command ATS0=1), the DTR signal confirms to the modem that the computer is available to accept a call.
The modem connects to a single computer or router, through an Ethernet port, USB port, or is installed in a computer PCI slot. The more common DSL router is a standalone device that combines the function of a DSL modem and a router, and can connect multiple computers through multiple Ethernet ports or an integral wireless access point.
Real mode causes the processor to mostly act as if it was an original 8086, while virtual 8086 mode allows the creation of a virtual machine to allow the running of programs that require real mode in order to run under a protected mode environment. Protected mode is the non-legacy mode of 32-bit x86 processors and the 80286.