Search results
Results from the WOW.Com Content Network
A feature's orientation can also be represented by dip and dip direction, using the azimuth of the dip rather than the strike value. Linear features are similarly measured with trend and plunge, where "trend" is analogous to dip direction and "plunge" is the dip angle. [3] Strike and dip are measured using a compass and a clinometer. A compass ...
Magnetic dip causes the compass to dip upward or downward depending on the latitude. Illustration of magnetic dip from Norman's book, The Newe Attractive. Magnetic dip, dip angle, or magnetic inclination is the angle made with the horizontal by Earth's magnetic field lines. This angle varies at different points on Earth's surface.
One first reads the scale that shows the angle subtended by the lid of the compass, and then depending on the colour shown (red or black) the end of the compass needle with the corresponding colour. Data are then recorded as (for example) 25°->333° (dip and dip-direction) or (plunge and plunge-direction).
Faults are mainly classified in terms of the angle that the fault plane makes with the Earth's surface, known as the dip, and the direction of slip along the fault plane. [17] Based on the direction of slip, faults can be categorized as: strike-slip, where the offset is predominantly horizontal, parallel to the fault trace;
Strike and dip symbols consist of a long "strike" line, which is perpendicular to the direction of greatest slope along the surface of the bed, and a shorter "dip" line on side of the strike line where the bed is going downwards. The angle that the bed makes with the horizontal, along the dip direction, is written next to the dip line.
Dip angle may refer to: Magnetic dip, the angle of the Earth's magnetic field lines relative to the horizontal; Dip (geology), the angle of a planar geological ...
Dip direction is measured in 360 degrees, generally clockwise from North. For example, a dip of 45 degrees towards 115 degrees azimuth, recorded as 45/115. Note that this is the same as above. The term hade is occasionally used and is the deviation of a plane from vertical i.e. (90°-dip).
Dip is defined as the angle of the fault relative to the surface of the earth, which indicates the plane on which slip will occur. Lastly, in any non-vertical fault, the block above the fault is called the hanging wall, while the blockbelow the fault is called the footwall. [4] Normal and reverse dip-slip faults with labeled hanging wall and ...