Search results
Results from the WOW.Com Content Network
The Atari ST series has a digital-to-analog converter of 3-bits, eight levels per RGB channel, featuring a 9-bit RGB palette (512 colors).Depending on the (proprietary) monitor type attached, it displays one of the 320×200, 16-colors and 640×200, 4-colors modes with the color monitor, or the high resolution 640×400 black and white mode with the monochrome monitor.
EBU 100/0/100/0 Colour Bars Displayed colours are only approximate due to different transfer and colour spaces used on web pages and video (BT.601 or BT.709). An alternate form of colour bars is the 100% Colour Bars or EBU 100/0/100/0 Colour Bars pattern (specified in ITU-R Rec. BT.1729 [8]), also known as the RGB pattern or full field bars, which consists of eight vertical bars of 100% ...
The RGB color model itself does not define what is meant by red, green, and blue colorimetrically, and so the results of mixing them are not specified as absolute, but relative to the primary colors. When the exact chromaticities of the red, green, and blue primaries are defined, the color model then becomes an absolute color space , such as ...
A 15-pin VGA connector for a personal computer A 21-pin SCART or JP21 connector for a television. The various RGB (red, green, blue) analog component video standards (e.g., RGBS, RGBHV, RGsB) use no compression and impose no real limit on color depth or resolution, but require large bandwidth to carry the signal and contain a lot of redundant data since each channel typically includes much of ...
VGA section on the motherboard in IBM PS/55. The color palette random access memory (RAM) and its corresponding digital-to-analog converter (DAC) were integrated into one chip (the RAMDAC) and the cathode-ray tube controller was integrated into a main VGA chip, which eliminated several other chips in previous graphics adapters, so VGA only additionally required external video RAM and timing ...
The control signal is a square wave operating at 25 kHz, with the duty cycle determining the fan speed. 25 kHz is used to raise the sound of the signal above the range of human hearing; use of a lower frequency could produce an audible hum or whine. Typically a fan can be driven between about 30% and 100% of the rated fan speed, using a signal ...
Not to be confused with Printed electronics. "PC board" redirects here. For the mainboard of personal computers, see Motherboard. "Panelization" redirects here. For the page layout strategy, see N-up. Printed circuit board of a DVD player Part of a 1984 Sinclair ZX Spectrum computer board, a printed circuit board, showing the conductive traces, the through-hole paths to the other surface, and ...
The SGPIO bus consists of 4 signal lines and originates at the HBA, referred to as the initiator and ends at a back-plane, referred to as the target. If a back-plane (or target) is not present the HBA may still drive the bus without any harm to the system; if one does exist, it can communicate back to the HBA using the 4th wire.