enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. ISO 898 - Wikipedia

    en.wikipedia.org/wiki/ISO_898

    ISO 898 is an international standard that defines mechanical and physical properties for metric fasteners. This standard is the origin for other standards that define properties for similar metric fasteners, such as SAE J1199 and ASTM F568M. [1] It is divided into five (nonconsecutive) parts: 1.

  3. Torque-to-yield fastener - Wikipedia

    en.wikipedia.org/wiki/Torque-to-yield_fastener

    The torque applied to the fastener must be determined such that it does not contribute to a service condition where the fastener enters a low-cycle fatigue regime. In general, the use of torque-to-yield fasteners is deprecated except in cases where the materials and structures comprising the entire assembly are certified to be within tolerances ...

  4. Bolted joint - Wikipedia

    en.wikipedia.org/wiki/Bolted_joint

    The applied torque causes the bolt to "climb" the thread causing a tensioning of the bolt and an equivalent compression in the components being fastened by the bolt. The preload developed in a bolt is due to the applied torque and is a function of the bolt diameter, the geometry of the threads, and the coefficients of friction that exist in the ...

  5. Preload control - Wikipedia

    en.wikipedia.org/wiki/Preload_control

    bolt-strecth method utilizes a hydraulic ram that stretches the bolt by pulling on the threaded section of the bolt that protrudes through the nut. Nut is rotated into position with very small torque applied. Once the external stretching force is removed, the preload is established; heat tightening is based on stretching the bolt by heating it ...

  6. List of screw drives - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_drives

    Standard 12-point hex socket bits and wrenches fit these screws. The screw heads are typically flanged, and may fit into standard Allen hex socket cap screw counterbores molded or machined into parts to be fastened. Compared to Allen hex sockets, the advantages of these bolts include higher torque capability and the lack of a recess to trap water.

  7. List of DIN standards - Wikipedia

    en.wikipedia.org/wiki/List_of_DIN_standards

    Fasteners – Part 15: Technical delivery conditions; Prevailing torque type nuts: Withdrawn: DIN EN ISO 2320, DIN EN ISO 3506-1, DIN EN ISO 3506-2, DIN EN ISO 3506-3: ISO 2320, ISO 3506-1, ISO 3506-2, ISO 3506-3: DIN 267-18: Fasteners – Part 18: Technical delivery conditions; Components made of Non-ferrous Metals: Withdrawn: DIN EN 28839 ...

  8. Unified Thread Standard - Wikipedia

    en.wikipedia.org/wiki/Unified_Thread_Standard

    The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

  9. ASTM A325 - Wikipedia

    en.wikipedia.org/wiki/ASTM_A325

    ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter. [1]