enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Machine taper - Wikipedia

    en.wikipedia.org/wiki/Machine_taper

    The rate of taper is 1:20 on diameter, in other words 0.600" on diameter per foot, .050" on diameter per inch. Tapers range from a Number 2 to a Number 20. The diameter of the big end in inches is always the taper size divided by 8, the small end is always the taper size divided by 10 and the length is the taper size divided by 2.

  3. Girard form class - Wikipedia

    en.wikipedia.org/wiki/Girard_form_class

    Girard form class is a form quotient calculated as the ratio of diameter inside bark at the top of the first 16 foot log to the diameter outside bark at breast height ().Its purpose is to estimate board-foot volume of whole trees from measurement of DBH, estimation of the number of logs, and estimation of the taper of the first log, based on the general relationships identified between the ...

  4. Tree taper - Wikipedia

    en.wikipedia.org/wiki/Tree_taper

    Tree taper is the degree to which a tree's stem or bole decreases in diameter as a function of height above ground. Within Forestry and for the purposes of timber production, trees with a high degree of taper are said to have poor form, while those with low taper have good form. The opposite is the case for open-grown amenity trees.

  5. National pipe thread - Wikipedia

    en.wikipedia.org/wiki/National_pipe_thread

    The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread. The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′.

  6. Tree volume measurement - Wikipedia

    en.wikipedia.org/wiki/Tree_volume_measurement

    The volume of the limbs and branches can be significant. For example, the Middleton Live Oak (Quercus virginiana), height 67.4 feet, dbh 10.44 feet, crown spread 118 feet) was found to have a trunk volume of 970 ft 3 (24.5 m 3) and a branch volume of 3,850 ft 3 (109 m 3) [15] The branch volume was almost

  7. List of drill and tap sizes - Wikipedia

    en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

    The major minus pitch technique also works for inch-based threads, but you must first calculate the pitch by converting the fraction of threads-per-inch (TPI) into a decimal. For example, a screw with a pitch of 1/20 in (20 threads per inch) has a pitch of 0.050 in and a 1 ⁄ 13 in pitch (13 threads per inch) has a pitch of 0.077 in.

  8. Shop these 10 thoughtful gifts under $50 from Nordstrom that ...

    www.aol.com/lifestyle/shop-these-10-thoughtful...

    Shop these 10 thoughtful gifts under $50 from Nordstrom that’ll arrive in time for Christmas

  9. Taper pin - Wikipedia

    en.wikipedia.org/wiki/Taper_pin

    A form of taper pin that precedes these standards is the clock pin, used to accurately and repeatably register parts of a clock to one another. Clock pins do not have a standardised taper, but they generally have a more pronounced taper than the standard engineering pins. The size or gauge is defined by diameter at each end, and the length.