Search results
Results from the WOW.Com Content Network
MII has two signal interfaces: A Data interface to the Ethernet MAC, for sending and receiving Ethernet frame data. A PHY management interface, MDIO, used to read and write the control and status registers of the PHY in order to configure each PHY before operation, and to monitor link status during operation.
The signal standard and pinout are backward-compatible with CGA, allowing EGA monitors to be used on CGA cards and vice versa. Early VGA cards also used this connector. VGA connector (DE-15) Became a nearly ubiquitous analog computer display connector after first being introduced with IBM x86 machines. Older VGA connectors were DE-9 (9-pin).
A flat-panel display (FPD) computer monitor A cathode-ray tube (CRT) computer monitor. A computer monitor is an output device that displays information in pictorial or textual form. A discrete monitor comprises a visual display, support electronics, power supply, housing, electrical connectors, and external user controls.
A further complication is that a device traditionally considered an input device, e.g., card reader, keyboard, may accept control commands to, e.g., select stacker, display keyboard lights, while a device traditionally considered as an output device may provide status data (e.g., low toner, out of paper, paper jam).
A composite monitor must have a two-dimensional approximately flat display device with circuitry to accept a composite signal with picture and synchronisation information, process it into monochrome chrominance and luminance, or the red, green, and blue of RGB, plus synchronisation pulses, and display it on a screen, which was predominantly a ...
Nixie tubes, LED display and VF display, top to bottom Display board at Frankfurt (Main) Hauptbahnhof (2005). A display device is an output device for presentation of information in visual [1] or tactile form (the latter used for example in tactile electronic displays for blind people). [2]
In addition to digital, some DVI connectors also have pins that pass an analog signal, which can be used to connect an analog monitor. The analog pins are the four that surround the flat blade on a DVI-I or DVI-A connector. A VGA monitor, for example, can be connected to a video source with DVI-I through the use of a passive adapter. Since the ...
This monitor as well as others that could be manually switched between these two sync rates were known as dual-scan displays. [ 6 ] The NEC Multisync was released in 1985 for use with the IBM PC, supporting a wide range of sync frequencies including those for CGA, EGA, various extended forms of those standards marketed by third party vendors ...