enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ribbon cable - Wikipedia

   en.wikipedia.org/wiki/Ribbon_cable

   Many-wire ribbon cable was invented in 1956 by Cicoil Corporation, a company based in Chatsworth, California. The company's engineers figured out how to use a new material, silicone rubber, to 'mold' a flat cable containing multiple conductors of the same size. Since the cable looked like a flat ribbon or duct tape, it was named a ribbon cable.

3. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

4. Wire stripper - Wikipedia

   en.wikipedia.org/wiki/Wire_stripper

   A US-style simple manual crimping/wire stripper tool is a pair of opposing blades much like scissors or wire cutters.The addition of a center notch makes it easier to cut the insulation without cutting the wire.

5. The Eraser Company - Wikipedia

   en.wikipedia.org/wiki/The_Eraser_Company

   Since then, the company developed its capabilities beyond magnet wire stripping into cable, wire and tube processing (stripping, feeding, cutting, twisting, measuring, dereeling) equipment, and infrared heating devices. [2] [5] The company is family owned and operated and has been based in Syracuse, NY since its establishment.

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   A common example is the multi-conductor flat ribbon cable used in computer disk drives; to terminate each of the many (approximately 40) wires individually would be slow and error-prone, but an insulation displacement connector can terminate all the wires in a single action.

7. Wire wrap - Wikipedia

   en.wikipedia.org/wiki/Wire_wrap

   Mechanical wire wrap tool Electrical wire wrap tool; pneumatic (air-powered) tools are also available. A "wire wrap tool" has two holes. The wire and 1 ⁄ 4 in (6.4 mm) of insulated wire are placed in a hole near the edge of the tool. The hole in the center of the tool is placed over the post. The tool is rapidly twisted.