Search results
Results from the WOW.Com Content Network
Articulated trams, were invented and first used by the Boston Elevated Railway in 1912–13. [2] This was instead of using trailers or multiple units, which had been attempted in the early 1900s. The articulated design allows passengers (and fare inspectors) to move the entire length of the vehicle, whether stopped or in motion.
Download as PDF; Printable version; In other projects ... Pages in category "Articulated vehicles" The following 22 pages are in this category, out of 22 total.
Articulated passenger cars are becoming increasingly common in Europe and the US. The passageways between the car elements are permanently attached. There is a safety benefit claimed that if the train derails, it is less likely to jackknife and modern construction techniques prevent telescoping. Articulated cars are not, however, a new idea.
Articulated tram GT3 in Bremen Type F in Vienna. In 1928 an experimental tram was constructed in Görlitz and then put into service in Dresden until the mid-1960s. This car was numbered 2501 and had three sections: the center section had four fixed wheels, both end sections had each only one adjustable axle. [4]
Tracked articulated vehicles typically steer by actuating the linkage connecting the cars of an articulated tracked vehicle. This linkage, called the train joint, uses hydraulic actuators [ 1 ] to position the front vehicle in an opposing direction to the rear one, and curves the direction of travel this way. [ 2 ]
A less common variant of the articulated bus is the bi-articulated bus, where the vehicle has two trailer sections rather than one. Such vehicles have a capacity of around 200 people, and a length of about 25 m (82 ft); as such, they are used almost exclusively on high-capacity, high-frequency arterial routes and on bus rapid transit services.
A bi-articulated bus is a long vehicle and usually requires a specially trained driver, as maneuvering (particularly reversing) can be difficult. Articulated electric trolleybuses can be difficult to control, with their motors producing momentary peak power in excess of 600 kilowatts (816 PS; 805 hp).
To fill the need for such vehicles, a specialized design bureau was established with the task of developing articulated tracked vehicles. Also a military vehicle able to operate on USSR northern borders was deemed necessary. In February 1971 the first two ATVs, designated DT-LP and DT-L, were produced for the State trials.