Search results
Results from the WOW.Com Content Network
Management Data Input/Output (MDIO), also known as Serial Management Interface (SMI) or Media Independent Interface Management (MIIM), is a serial bus defined for the Ethernet family of IEEE 802.3 standards for the Media Independent Interface, or MII. The MII connects media access control (MAC) devices with Ethernet physical layer (PHY ...
Asynchronous serial communication is a form of serial communication in which the communicating endpoints' interfaces are not continuously synchronized by a common clock signal. Instead of a common synchronization signal, the data stream contains synchronization information in form of start and stop signals, before and after each unit of ...
Several factors allow serial to be clocked at a higher rate: Clock skew between different channels is not an issue (for unclocked asynchronous serial communication links). This can be caused by mismatched wire or conductor lengths. [17] [18] A serial connection requires fewer interconnecting cables (e.g., wires/fibers) and hence occupies less ...
Synchronous serial communication describes a serial communication protocol in which "data is sent in a continuous stream at constant rate." [1]Synchronous communication requires that the clocks in the transmitting and receiving devices are synchronized – running at the same rate – so the receiver can sample the signal at the same time intervals used by the transmitter.
It is frequently used to implement the serial port for IBM PC compatible personal computers, where it is often connected to an RS-232 interface for modems, serial mice, printers, and similar peripherals. It was the first serial chip used in the IBM PS/2 line, which were introduced in 1987. [2] [3] [4] The part was originally made by National ...
Get answers to your AOL Mail, login, Desktop Gold, AOL app, password and subscription questions. Find the support options to contact customer care by email, chat, or phone number.
Sending data from sub to main may use the opposite clock edge as main to sub. Devices often require extra clock idle time before the first clock or after the last one, or between a command and its response. Some devices have two clocks, one to read data, and another to transmit it into the device. Many of the read clocks run from the chip ...
A secondary which does not see any incoming traffic for a long time begins sending "beacon" response frames, telling the primary that the link between that secondary and its predecessor is broken. Because the primary also receives a copy of the commands it sent, which are indistinguishable from responses, it appends a special "turnaround" frame ...