enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fastener - Wikipedia

   en.wikipedia.org/wiki/Fastener

   B18.3 Socket Cap, Shoulder, Set Screws, and Hex Keys (Inch Series) B18.6.1 Wood Screws (Inch Series) B18.6.2 Slotted Head Cap Screws, Square Head Set Screws, And Slotted Headless Set Screws (Inch Series) B18.6.3 Machine Screws, Tapping Screws, and Metallic Drive Screws (Inch Series) B18.18 Quality Assurance For Fasteners

3. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Instead of covering up the screw head that it serves as an aesthetic part of the design. Ten different recess sizes are available for the Mortorq. The smallest of these, the PMT-000 can be used with screws that have a head diameter as small as 2.5 mm. While the largest called PMT-7 can be used on screws with a head diameter of 35 mm. [35]

4. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   Self-tapping screws have a wide range of tip and thread patterns, and are available with almost any possible screw head design. Common features are the screw thread covering the whole length of the screw from tip to head and a pronounced thread hard enough for the intended substrate, often case-hardened. [1]

5. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...

6. The Most Common Reasons People See the Doctor for Scalp Pain

   www.aol.com/most-common-reasons-people-see...

   Ready to file your taxes? You can get TurboTax for 30% off on Amazon today

7. Bolted joint - Wikipedia

   en.wikipedia.org/wiki/Bolted_joint

   Where L e is the thread engagement length, A t is the tensile stress area, D is the major diameter of the screw, and p is the pitch. This equation only holds true if the screw and female thread materials are the same. If they are not the same, then the following equations can be used to determine the additional thread length that is required: [14]