Search results
Results from the WOW.Com Content Network
The Westinghouse Combustion Turbine Systems Division (CTSD), part of Westinghouse Electric Corporation's [1] Westinghouse Power Generation [2] group, was originally located, along with the Steam Turbine Division (STD), in a major industrial manufacturing complex, referred to as the South Philadelphia Works, in Lester, Pennsylvania near to the Philadelphia International Airport.
A magnetic starter has a contactor and an overload relay, which will open the control voltage to the starter coil if it detects an overload on a motor. [1] [2] The overload relay opens a set of contacts that are wired in series with the supply to the contactor feeding the motor. The characteristics of the heaters can be matched to the motor so ...
Media in category "Uninterruptible power supply" This category contains only the following file. Smartups-2200xlrm3u-inside.jpg 1,067 × 729; 409 KB
This is a list of the power supply systems that are, or have been, used for railway electrification. Note that the voltages are nominal and vary depending on load and distance from the substation. As of 2023 many trams and trains use on-board solid-state electronics to convert these supplies to run three-phase AC traction motors.
An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.
The magnetic amplifier (colloquially known as a "mag amp") is an electromagnetic device for amplifying electrical signals. The magnetic amplifier was invented early in the 20th century, and was used as an alternative to vacuum tube amplifiers where robustness and high current capacity were required.
This provides double protection from both a power supply failure and a UPS failure, so that continued operation is assured. This configuration is also referred to as 1 + 1 or 2N redundancy. If the budget does not allow for two identical UPS units then it is common practice to plug one power supply into mains power and the other into the UPS ...
The first German jet engines built during the Second World War used a mechanical APU starting system designed by the German engineer Norbert Riedel.It consisted of a 10 horsepower (7.5 kW) two-stroke flat engine, which for the Junkers Jumo 004 design was hidden in the intake diverter, essentially functioning as a pioneering example of an auxiliary power unit for starting a jet engine.