enow.com Web Search

  1. Ads

    related to: idc ribbon cable crimping tool home depot how you use

Search results

  1. Results from the WOW.Com Content Network
  2. Punch down tool - Wikipedia

    en.wikipedia.org/wiki/Punch_down_tool

    A punch down tool, punchdown tool, IDC tool, or a Krone tool (named after the Krone LSA-PLUS connector), is a small hand tool used by telecommunication and network technicians. It is used for inserting wire into insulation-displacement connectors on punch down blocks , patch panels , keystone modules , and surface mount boxes (also known as ...

  3. IDC (electrical connector) - Wikipedia

    en.wikipedia.org/wiki/IDC_(electrical_connector)

    Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

  4. Ribbon cable - Wikipedia

    en.wikipedia.org/wiki/Ribbon_cable

    Left: 20-way grey ribbon cable with wire for pin 1 marked red, insulation partly stripped. Right: 16-way rainbow ribbon with IDC connector. IDC D-sub connectors DE-9 (male) and DA-15 (female) Twisted ribbon cable used for Parallel SCSI connections. A ribbon cable is a cable with many conducting wires running parallel to each other on the same ...

  5. 110 block - Wikipedia

    en.wikipedia.org/wiki/110_block

    A 110 punch block. A 110 block is a type of punch-down block used to terminate runs of on-premises wiring in a structured cabling system. The designation 110 is also used to describe a type of insulation displacement contact (IDC) connector used to terminate twisted pair cables, [1] which uses a punch-down tool similar to the type used for the older 66 block.

  6. D-subminiature - Wikipedia

    en.wikipedia.org/wiki/D-subminiature

    Crimp contacts are assembled by inserting a stripped wire end into a cavity in the rear of the contact, then crushing the cavity using a crimp tool, causing the cavity to grip the wire tightly at many points. The crimped contact is then inserted into the connector where it locks into place.

  7. NYT ‘Connections’ Hints and Answers Today, Friday, December 13

    www.aol.com/nyt-connections-hints-answers-today...

    Read no further until you really want some clues or you've completely given up and want the answers ASAP. Get ready for all of today's NYT 'Connections’ hints and answers for #551 on Friday ...

  8. Neuer gets sent off for 1st time and Bayern Munich exits ...

    www.aol.com/neuer-gets-sent-off-1st-220513912.html

    Manuel Neuer was sent off for the first time and Bayern Munich crashed out of the German Cup in the third round with a 1-0 loss at home to defending champion Bayer Leverkusen on Tuesday. The 38 ...

  9. Florida man accused of hate crime in deadly shooting of gay ...

    www.aol.com/florida-man-accused-hate-crime...

    A Florida man accused of a hate crime for killing a gay man is asking a judge to dismiss the charges, saying he acted in self-defense.

  1. Ads

    related to: idc ribbon cable crimping tool home depot how you use