Search results
Results from the WOW.Com Content Network
It translates into 1 part in about 58,000 parts of water or 17.1 parts per million (ppm). ... 1 mg/L (ppm) = 0.058417831 grains per US gallon; See also. dGH; References
At 1 ppm the solution is a very pale yellow. As the concentration increases the colour becomes a more vibrant yellow, then orange, with the final 10,000 ppm a deep red colour. In science and engineering , the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities , e.g. mole fraction or ...
Parts per million (ppm) is usually defined as 1 mg/L CaCO 3 (the definition used below). [20] It is equivalent to mg/L without chemical compound specified, and to American degree . Grain per gallon (gpg) is defined as 1 grain (64.8 mg) of calcium carbonate per U.S. gallon (3.79 litres), or 17.118 ppm.
Atmospheric pollutant concentrations expressed as mass per unit volume of atmospheric air (e.g., mg/m 3, μg/m 3, etc.) at sea level will decrease with increasing altitude because the atmospheric pressure decreases with increasing altitude.
Nashville's Metro Water Services maintains a fluoride level of approximately 0.7 mg/L (or ppm) in its drinking water, Sonia Allman, manager of strategic communications, said in an email to The ...
where: mg/m 3 = milligrams of pollutant per cubic meter of air at sea level atmospheric pressure and T: ppmv = air pollutant concentration, in parts per million by volume
Since one degree KH = 17.848 mg/L CaCO 3, this solution has a KH of 4.0052 degrees. Carbonate hardness should not be confused with a similar measure Carbonate Alkalinity which is expressed in either [milli[equivalent]s] per litre (meq/L) or ppm. Carbonate hardness expressed in ppm is exactly equal to carbonate alkalinity expressed in ppm.
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]