Search results
Results from the WOW.Com Content Network
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.
A device capable of more than bridging is known as a multilayer switch. A layer 2 network device is a multiport device that uses hardware addresses (MAC addresses) to process and forward data at the data link layer (layer 2). A switch operating as a network bridge may interconnect otherwise separate layer 2 networks.
The difference between a layer-3 switch and a router is the way the device is making the routing decision. Conventionally, routers use microprocessors to make forwarding decisions in software, while the switch performs only hardware-based packet switching (by specialized ASICs with the help of content-addressable memory).
USB3 Gen X follows the Enhanced SuperSpeed Hub topology, where every USB4 router with more than one USB3 endpoint must include a USB3 hub as well. It is the default way USB3 connections through USB4 are made. Supporting it at 10 Gbit/s (SuperSpeed USB 10 Gbps, Gen 2x1) is mandatory on every USB4 DFP. The minimum supported speed for the USB3 ...
Any USB 2.0 hub that supports a higher standard than USB 1.1 (12 Mbit/s) will translate between the lower standard and the higher standard using what is called a transaction translator (TT). For example, if a USB 1.1 device is connected to a port on a USB 2.0 hub, then the TT would automatically recognize and translate the USB 1.1 signals to ...
Rather than tie up the high-bandwidth USB bus sending data to a slower USB device, the nearest high-bandwidth capable hub receives a SPLIT token followed by one or two USB packets at high-bandwidth, performs the data transfer at full- or low-bandwidth, and provides the response at high-bandwidth when prompted by a second SPLIT token.
Therefore, a compromise between a hub and a switch was developed, known as a dual-speed hub. These devices make use of an internal two-port switch, bridging the 10 Mbit/s and 100 Mbit/s segments. When a network device becomes active on any of the physical ports, the device attaches it to either the 10 Mbit/s segment or the 100 Mbit/s segment ...
USB was designed to standardize the connection of peripherals to personal computers, both to exchange data and to supply electric power. It has largely replaced interfaces such as serial ports and parallel ports and has become commonplace on various devices.