Search results
Results from the WOW.Com Content Network
An eight-bit processor like the Intel 8008 addresses eight bits, but as this is the full width of the accumulator and other registers, this could be considered either byte-addressable or word-addressable. 32-bit x86 processors, which address memory in 8-bit units but have 32-bit general-purpose registers and can operate on 32-bit items with a ...
A memory address a is said to be n-byte aligned when a is a multiple of n (where n is a power of 2). In this context, a byte is the smallest unit of memory access, i.e. each memory address specifies a different byte. An n-byte aligned address would have a minimum of log 2 (n) least-significant zeros when expressed in binary.
In a computer using virtual memory, accessing the location corresponding to a memory address may involve many levels. In computing, a memory address is a reference to a specific memory location in memory used by both software and hardware. [1] These addresses are fixed-length sequences of digits, typically displayed and handled as unsigned ...
If a is later accessed again, its new value will be 8. This example may be clearer if memory is examined directly. Assume that a is located at address 0x8130 in memory and ptr at 0x8134; also assume this is a 32-bit machine such that an int is 32-bits wide. The following is what would be in memory after the following code snippet is executed:
Because of this, the lowest 3 bits of a heap reference will always be 0. By lowering the resolution of 32-bit references to 8 byte blocks, the addressable space can be increased to 32 GB. This significantly reduces memory use compared to using 64-bit references as Java uses references much more than some languages like C++. Java 8 supports ...
The DEC PDP-10, also 36-bit, had special instructions which allowed memory to be treated as a sequence of fixed-size bit fields or bytes of any size from 1 bit to 36 bits. A one-word sequence descriptor in memory, called a "byte pointer", held the current word address within the sequence, a bit position within a word, and the size of each byte.
8+: <0–3 bytes padding>, defaultbyte1, defaultbyte2, defaultbyte3, defaultbyte4, npairs1, npairs2, npairs3, npairs4, match-offset pairs... key → a target address is looked up from a table using a key and execution continues from the instruction at that address lor 81 1000 0001 value1, value2 → result bitwise OR of two longs lrem 71 0111 0001
Bank switching is a technique used in computer design to increase the amount of usable memory beyond the amount directly addressable by the processor [1] instructions. It can be used to configure a system differently at different times; for example, a ROM required to start a system from diskette could be switched out when no longer needed. In ...