Search results
Results from the WOW.Com Content Network
Then, the head on the pump is varied by some sort of adjustment such as throttling a discharge valve, utilizing different pump combinations in parallel, or adjusting well levels. [4] This allows the pump's performance to be tested across its range of operation as its head, and hence flow, is varied.
A slug test is a variation on the typical aquifer test where an instantaneous change (increase or decrease) is made, and the effects are observed in the same well. This is often used in geotechnical engineering settings to get a quick estimate (minutes instead of days) of the aquifer properties immediately around the well.
A drill stem test (DST) is a procedure for isolating and testing the pressure, permeability and productive capacity of a geological formation during the drilling of a well. The test is an important measurement of pressure behaviour at the drill stem and is a valuable way of obtaining information on the formation fluid and establishing whether a ...
Therefore, you can estimate the impact of changing one variable while keeping the others constant. When determining the ideal pump for a given application we are regularly changing the motor (i.e. altering the pump speed), or milling down the impeller diameter to tune the pump to operate at the flowrate and head needed for our system.
This file contains additional information, probably added from the digital camera or scanner used to create or digitize it. If the file has been modified from its original state, some details may not fully reflect the modified file.
Spicy Chick-Fil-A Chick-n-Strips. For those who crave a kick of heat, Chick-fil-A’s Spicy Chick-n-Strips were a standout hit. Chicken breast strips seasoned with a spicy blend of peppers quickly ...
In fluid dynamics, total dynamic head (TDH) is the work to be done by a pump, per unit weight, per unit volume of fluid.TDH is the total amount of system pressure, measured in feet, where water can flow through a system before gravity takes over, and is essential for pump specification.
A mortgage point could cost 1% of your mortgage amount, which means about $5,000 on a $500,000 home loan, with each point lowering your interest rate by about 0.25%, depending on your lender and loan.