enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Milwaukee Tool - Wikipedia

   en.wikipedia.org/wiki/Milwaukee_Tool

   In 1991, Milwaukee released the Milwaukee Super Sawzall, a reciprocating saw with built-in counterbalance, a gear-protecting clutch, and five different patents. In the later 1990s, Milwaukee Electric Tool Corporation released a new range of miter saws and a lineup of 18-volt contractor cordless tools.

3. Circular saw - Wikipedia

   en.wikipedia.org/wiki/Circular_saw

   A hand-held circular saw is the most conventional circular saw. This miter saw is a circular saw mounted to swing to crosscut wood at an angle. A table saw. Tractor-driven circular saw. A circular saw or a buzz saw, is a power-saw using a toothed or abrasive disc or blade to cut different materials using a rotary motion spinning around an arbor.

4. Riving knife - Wikipedia

   en.wikipedia.org/wiki/Riving_knife

   A riving knife to the left of the blade on table saw. A riving knife is a safety device installed on a table saw, circular saw, or radial arm saw used for woodworking. Attached to the saw's arbor, it is fixed relative to the blade and moves with it as blade depth is adjusted. [1]

5. Table saw - Wikipedia

   en.wikipedia.org/wiki/Table_saw

   The blade of a table saw cutting into wood. A table saw (also known as a sawbench or bench saw in England) is a woodworking tool, consisting of a circular saw blade, mounted on an arbor, that is driven by an electric motor (directly, by belt, by cable, or by gears).

6. Saw - Wikipedia

   en.wikipedia.org/wiki/Saw

   Circular saw: a saw with a circular blade which spins. Circular saws can be large for use in a mill or hand held up to 24" blades and different designs cut almost any kind of material including wood, stone, brick, plastic, etc. Table saw: a saw with a circular blade rising through a slot in a table. If it has a direct-drive blade small enough ...

7. Chainsaw - Wikipedia

   en.wikipedia.org/wiki/Chainsaw

   The end of the saw power head has two oil holes, one on each side. These holes must match with the outlet of the oil pump. The pump sends the oil through the hole in the lower part of the gauge. [citation needed] Saw bar producers provide a large variety of bars matching different saws. [citation needed]