enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. RF modulator - Wikipedia

   en.wikipedia.org/wiki/RF_modulator

   The modulator is then programmed to broadcast the signals on a certain frequency. That RF broadcast is then received by the connected TV. When the TV is tuned to the programmed channel, the video and audio signal of the source device is accessed. RF modulation can become difficult in a CATV system. High pass, low pass, and notch filters must be ...

3. Sup'R'Mod - Wikipedia

   en.wikipedia.org/wiki/Sup'R'Mod

   Composite video is received by the circuit board through a short cable terminating in a Molex connector, which plugs into a header on the Apple II motherboard. Input can also be provided through an RCA connector. The output of the RF modulator goes out through a coaxial cable to the antenna switch. [5] [6]

4. Digital television adapter - Wikipedia

   en.wikipedia.org/wiki/Digital_television_adapter

   A converter box takes the digital signal from the antenna and outputs composite video (for SD TVs) or HDMI (for HD TVs). A RF/antenna output, if present on a converter box, is usually just a passthrough ("LOOP OUT" which does not provide the box's output signal, but only provides the raw antenna input signal to watch analog channels via a TV ...

5. List of video connectors - Wikipedia

   en.wikipedia.org/wiki/List_of_video_connectors

   An attempt by Apple to deal with cable clutter, by combining five separate cables from computer to monitor. Female port (20-pin) Digital Flat Panel (DFP) Used with the PanelLink digital video protocol. Deprecated. Made obsolete by DVI. 3D model of a UDI connector Unified Display Interface: Proposed to replace both DVI and HDMI.

6. Composite video - Wikipedia

   en.wikipedia.org/wiki/Composite_video

   The process of modulating RF with the original video signal, and then demodulating the original signal again in the TV, introduces losses including added noise or interference. For these reasons, it is best to use composite connections instead of RF connections if possible for live signals and sample the source FM RF signal for recorded formats.

7. Amiga video connector - Wikipedia

   en.wikipedia.org/wiki/Amiga_video_connector

   The Amiga 520 adapter allowed for RF modulated and composite video output, to be connected to a TV. Alternatively, Commodore sold an adapter (the A520), that attached to the Amiga video connector and provided composite and RF outputs appropriate to the region in which it was sold. [2]