Search results
Results from the WOW.Com Content Network
The solvent to use is dependent on two factors: the agent that is causing the stain, and the material that has been stained. Different solvents will dissolve different stains, and the application of some solvents is limited by the fact that they not only dissolve the stain, but also dissolve the material that is stained as well. [1]
Usually to remove the bulk of the material, and prepare it for the cleaning tank. Although if the part does not need to be perfectly clean, then the operation can be ended after spraying. Spraying can also be used as a prequel other degreasing operations such as vapor degreasing which gives a better clean.
Monolithic microwave integrated circuit, or MMIC (sometimes pronounced "mimic"), is a type of integrated circuit (IC) device that operates at microwave frequencies (300 MHz to 300 GHz). These devices typically perform functions such as microwave mixing , power amplification, low-noise amplification , and high-frequency switching.
Vacuum microwave drying is used for the US Army's experimental Close Combat Assault Ration. [ 3 ] Freeze drying or lyophilization is a drying method where the solvent is frozen prior to drying and is then sublimed , i.e., passed to the gas phase directly from the solid phase, below the melting point of the solvent.
Grease fitting on a bearing A grease nipple on the driver's door of a 1956 VW Beetle. A grease fitting, grease nipple, Zerk fitting, grease zerk, Alemite fitting, or divit is a metal fitting used in mechanical systems to feed lubricants, usually lubricating grease, into a bearing under moderate to high pressure using a grease gun.
At microwave frequencies, this material is usually a ferrite which is biased by a static magnetic field [1] but can be a self-biased material. [2] The ferrite is positioned within the isolator such that the microwave signal presents it with a rotating magnetic field, with the rotation axis aligned with the direction of the static bias field.
The ground-glass rim of the desiccator lid must be greased with a thin layer of vacuum grease, petroleum jelly or other lubricant to ensure an airtight seal. In order to prevent damage to a desiccator the lid should be carefully slid on and off instead of being directly placed onto the base.
Grease is a solid or semisolid lubricant formed as a dispersion of thickening agents in a liquid lubricant. Grease generally consists of a soap emulsified with mineral or vegetable oil .