Search results
Results from the WOW.Com Content Network
Monolithic microwave integrated circuit, or MMIC (sometimes pronounced "mimic"), is a type of integrated circuit (IC) device that operates at microwave frequencies (300 MHz to 300 GHz). These devices typically perform functions such as microwave mixing , power amplification, low-noise amplification , and high-frequency switching.
Microwave digestion is a chemical technique used to decompose sample material into a solution suitable for quantitative elemental analysis. [1] It is commonly used to prepare samples for analysis using inductively coupled plasma mass spectrometry (ICP-MS) , atomic absorption spectroscopy , and atomic emission spectroscopy (including ICP-AES ).
Usually to remove the bulk of the material, and prepare it for the cleaning tank. Although if the part does not need to be perfectly clean, then the operation can be ended after spraying. Spraying can also be used as a prequel other degreasing operations such as vapor degreasing which gives a better clean.
The solvent to use is dependent on two factors: the agent that is causing the stain, and the material that has been stained. Different solvents will dissolve different stains, and the application of some solvents is limited by the fact that they not only dissolve the stain, but also dissolve the material that is stained as well. [1]
Vacuum microwave drying is used for the US Army's experimental Close Combat Assault Ration. [ 3 ] Freeze drying or lyophilization is a drying method where the solvent is frozen prior to drying and is then sublimed , i.e., passed to the gas phase directly from the solid phase, below the melting point of the solvent.
Cross-section of microstrip geometry. Conductor A is separated from ground plane D by dielectric substrate C.Upper dielectric B is typically air.. Microstrip is a type of electrical transmission line which can be fabricated with any technology where a conductor is separated from a ground plane by a dielectric layer known as substrate.
A splash guard prevents ingredients from flying out of the bowl, especially when adding dry ingredients or mixing at high speeds. "It keeps your workspace and mixer cleaner," Stewart says.
The forming tools must pass through microwaves for this to work well. Because sodium silicate has a high dielectric constant, it absorbs microwave energy very rapidly. Fully dehydrated sand shapes can be produced within a minute of microwave exposure. This method produces the highest strength of sand shapes bonded with sodium silicate.