Search results
Results from the WOW.Com Content Network
A towing sock or wire rope puller or wire pulling grip is a device that connects to the end of a cable, such as a power cable, in order to pull it through a tube or tunnel. [1] It works by tightening around the cable when pulled, in the same manner as a Chinese finger trap . [ 2 ]
A similar heavy-duty unit with a combination chain and cable became available in 1935 that was used by railroads, but lacked the success of the cable-only type units. [ 1 ] A similar tool to a come-along is a cable puller , which does not have a drum and ratchet but directly grips the cable, allowing unlimited lengths of wire rope to be used.
Diagram of a simple electrical cable with three insulated conductors, with IEC colour scheme About 1950, PVC insulation and jackets were introduced, especially for residential wiring. About the same time, single conductors with a thinner PVC insulation and a thin nylon jacket (e.g. US Type THN, THHN, etc.) became common.
A typical one-line diagram with annotated power flows. Red boxes represent circuit breakers, grey lines represent three-phase bus and interconnecting conductors, the orange circle represents an electric generator, the green spiral is an inductor, and the three overlapping blue circles represent a double-wound transformer with a tertiary winding.
Electrical cable diagram Flexible mains cable with three 2.5 mm solid copper conductors. An electrical cable is an assembly of one or more wires running side by side or bundled, which is used as an electrical conductor to carry electric current.
High voltage is defined as any voltage over 1000 volts. [3] Those of 2 to 33 kV are usually called medium voltage cables, those over 50 kV high voltage cables.. Modern HV cables have a simple design consisting of a few parts: the conductor, the conductor shield, the insulation, the insulation shield, the metallic shield, and the jacket.
Accordingly, the workspace of cable robots is defined as a region in space where the end-effector is able to exert the required wrench (force and moment vectors) to the surroundings while all cables are in tension (non-negative forces). Many research works have focused on workspace analysis and optimization of cable robots.
The ALCO RS-27 (specification DL-640) was a diesel-electric locomotive built by ALCO between December 1959 and October 1962. Only 27 examples were manufactured. [ 1 ] With ALCO's introduction of the Century Series line in 1963, the C-424 (specification DL-640A) replaced the RS-27 in the builder's catalog.