enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Charge controller - Wikipedia

   en.wikipedia.org/wiki/Charge_controller

   By way of example, a 150 volt PV array connected to an MPPT charge controller can be used to charge a 24 or 48 volt battery. Higher array voltage means lower array current, so the savings in wiring costs can more than pay for the controller. [citation needed] Charge controllers may also monitor battery temperature to prevent overheating.

3. Battery charger - Wikipedia

   en.wikipedia.org/wiki/Battery_charger

   A battery charger, recharger, or simply charger, [1] [2] is a device that stores energy in an electric battery by running current through it. The charging protocol—how much voltage and current, for how long and what to do when charging is complete—depends on the size and type of the battery being charged.

4. Uninterruptible power supply - Wikipedia

   en.wikipedia.org/wiki/Uninterruptible_power_supply

   If a battery has been completely discharged (e.g. the car lights were left on overnight) and next is given a fast charge for only a few minutes, then during the short charging time it develops only a charge near the interface. The battery voltage may rise to be close to the charger voltage so that the charging current decreases significantly.

5. 48-volt electrical system - Wikipedia

   en.wikipedia.org/wiki/48-volt_electrical_system

   A 48 V system can provide more power, improve energy recuperation, [7] and allow up to an 85% decrease in cable mass. [10]12-volt systems can provide only 3.5 kilowatts, while a 48 V power could achieve 15 to 20 kW or even 50 kW. 48 volts is below the level that is considered safe in dry conditions without special protective measures. [11]

6. Smart battery - Wikipedia

   en.wikipedia.org/wiki/Smart_battery

   A smart battery or a smart battery pack is a rechargeable battery pack with a built-in battery management system (BMS), usually designed for use in a portable computer such as a laptop. [ 1 ] [ 2 ] In addition to the usual positive and negative terminals, a smart battery has two or more terminals to connect to the BMS; typically the negative ...

7. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   Sleep-and-charge USB ports can be used to charge electronic devices even when the computer that hosts the ports is switched off. Normally, when a computer is powered off the USB ports are powered down. This feature has also been implemented on some laptop docking stations allowing device charging even when no laptop is present. [82]

8. Power supply - Wikipedia

   en.wikipedia.org/wiki/Power_supply

   In the event that an abnormal high-current power draw is detected, the switched-mode supply can assume this is a direct short and will shut itself down before damage is done. PC power supplies often provide a power good signal to the motherboard; the absence of this signal prevents operation when abnormal supply voltages are present.

9. Combined Charging System - Wikipedia

   en.wikipedia.org/wiki/Combined_Charging_System

   CCS1 (Combined Charging System Combo 1) plug as used in North America. It is an extension of the J1772 standard AC charging connector. CCS Combo 1 vehicle inlet showing the J1772 and the two DC fast-charging pins Connectors: Incomplete Combo 2 (left) showing the two large direct current (DC) pins below, while the four alternating current (AC) pins for neutral and three-phase are removed, while ...