Ads
related to: wireless water tank level monitoring system using esp32 and arduino sensor
Search results
Results from the WOW.Com Content Network
Wireless sensor networks also are used for the collection of data for monitoring of environmental information. [20] This can be as simple as monitoring the temperature in a fridge or the level of water in overflow tanks in nuclear power plants. The statistical information can then be used to show how systems have been working.
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
Air bubbler systems contain no moving parts, making them suitable for measuring the level of sewage, drainage water, sewage sludge, night soil, or water with large quantities of suspended solids. The only part of the sensor that contacts the liquid is a bubble tube which is chemically compatible with the material whose level is to be measured.
Electronic components used to make a simple water detector: battery, resistor, transistor, water sensor and piezoelectric buzzer for audible alert A water detector is an electronic device that is designed to detect the presence of water for purposes such as to provide an alert in time to allow the prevention of water leakage.
A float switch is a type of level sensor, a device used to detect the level of liquid within a tank. The switch may be used to control a pump, as an indicator, an alarm, or to control other devices. One type of float switch uses a mercury switch inside a hinged float.
Tank leak detection is implemented to alert the operator to a suspected release from any part of a storage tank system, what enables to prevent from soil contamination and loss of product. In many countries regulated UST are required to have an approved leak detection method so that leaks are discovered quickly and the release is stopped in time.
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...
NodeMCU was created shortly after the ESP8266 came out. On December 30, 2013, Espressif Systems [6] began production of the ESP8266. [12] NodeMCU started on 13 Oct 2014, when Hong committed the first file of nodemcu-firmware to GitHub. [13]
Ads
related to: wireless water tank level monitoring system using esp32 and arduino sensor