Search results
Results from the WOW.Com Content Network
Repeater frequency sets are known as "repeater pairs", and in the ham radio community most follow ad hoc standards for the difference between the two frequencies, commonly called the offset. In the USA two-meter band, the standard offset is 600 kHz (0.6 MHz), but sometimes unusual offsets, referred to as oddball splits, are used. The actual ...
WIRES II - Yaesu did terminate WIRES-II service on Saturday, September 30, 2017 at 06:00 UTC. They suggested in the future, to use the WIRES-X Internet linking system. [2] [3] WIRES-X - Supports the C4FM digital and the voice technology. It enables high sound quality by repeating C4FM digital data as it is via the Internet.
The 2-meter amateur radio band is a portion of the VHF radio spectrum that comprises frequencies stretching from 144 MHz to 148 MHz [1] in International Telecommunication Union region (ITU) Regions 2 (North and South America plus Hawaii) and 3 (Asia and Oceania) [2] [3] and from 144 MHz to 146 MHz in ITU Region 1 (Europe, Africa, and Russia).
Usually used as an ATV repeater output. VSB filters must be used on this channel to keep the signal inside the ham band. Channels 58 and 59 are often offset in frequency to limit interference to the weak-signal and amateur radio satellite sub-bands (431–433 & 435–438 MHz respectively). Many modern CATV receivers can still lock-on to ...
An extensive digital repeater, or "digipeater" network provides transport for APRS packets on these frequencies. Internet gateway stations (IGates) connect the on-air APRS network to the APRS Internet System (APRS-IS), which serves as a worldwide, high-bandwidth backbone for APRS data. Stations can tap into this stream directly, and a number of ...
In order to reduce the interference from the fringe area transmitters transmitting in the same channels, a method named frequency offset is often used. By this method, a slightly shifted RF is assigned for a transmitter which may experience interference from other transmitters. In TV transmission, the shifted RF is calculated by the formula;
A radio repeater is a combination of a radio receiver and a radio transmitter that receives a signal and retransmits it, so that two-way radio signals can cover longer distances. A repeater sited at a high elevation can allow two mobile stations, otherwise out of line-of-sight propagation range of each other, to communicate. [1]
The 2 200 metre band is available for use in several countries, and the 2007 World Radiocommunication Conference (WRC-07) recommended it as a worldwide amateur allocation. Before the introduction of the 2 200 metre band in the U.K. in 1998, operation on the even lower frequency of 73 kHz, in the LF time signal band, was allowed from 1996–2003.