Search results
Results from the WOW.Com Content Network
Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure everything was reset. Just wait about five minutes before turning it back on to make sure everything was reset.
In IEEE 802.11 wireless local area networking standards (including Wi‑Fi), a service set is a group of wireless network devices which share a service set identifier (SSID)—typically the natural language label that users see as a network name. (For example, all of the devices that together form and use a Wi‑Fi network called "Foo" are a ...
Hiding the network name may not deter attackers from connecting to the network. Hiding the SSID removes it from beacon frames, but this is only one of several ways an SSID can be discovered. [1] When users chooses to hide the network name from the router's setup page, it will only set the SSID in the beacon frame to null, but there are four ...
IEEE 1905.1 is an IEEE standard which defines a network enabler for home networking supporting both wireless and wireline technologies: IEEE 802.11 (marketed under the Wi-Fi trademark), IEEE 1901 (HomePlug, HD-PLC) power-line networking, IEEE 802.3 Ethernet and Multimedia over Coax (MoCA).
Each service set has an associated identifier, a 32-byte service set identifier (SSID), which identifies the network. The SSID is configured within the devices that are part of the network. A basic service set (BSS) is a group of stations that share the same wireless channel, SSID, and other settings that have wirelessly connected, usually to ...
In networks with distance-vector routing protocols, route flapping can trigger routing updates with every state change. In both cases, it prevents the network from converging. Route flapping can be contained to a smaller area of the network if route aggregation is used. As an aggregate route will not be withdrawn as long as at least one of the ...
Most network address translators map multiple private hosts to one publicly exposed IP address. Here is a typical configuration: A local network uses one of the designated private IP address subnets (RFC 1918 [5]). The network has a router having both a private and a public address.
The most common form of black hole is simply an IP address that specifies a host machine that is not running or an address to which no host has been assigned.. Even though TCP/IP provides a means of communicating the delivery failure back to the sender via ICMP, traffic destined for such addresses is often just dropped.