enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Push-to-pull compression fittings - Wikipedia

   en.wikipedia.org/wiki/Push-to-pull_compression...

   A push-in compression coupling and tee.. Push-to-pull, push-to-connect, push-in, push-fit, or instant fittings are a type of easily removed compression fitting or quick connect fitting that allows an air (or water) line to be attached, nominally without the use of tools (a tool is still usually required for cutting tubing to length and removal).

3. Standard dimension ratio - Wikipedia

   en.wikipedia.org/wiki/Standard_dimension_ratio

   Standard dimension ratio (SDR) is a method of rating a pipe's durability against pressure. The standard dimension ratio describes the correlation between the pipe dimension and the thickness of the pipe wall. [1] Common nominations are SDR11, SDR17, SDR26 and SDR35. Pipes with a lower SDR can withstand higher pressures.

4. List of software-defined radios - Wikipedia

   en.wikipedia.org/wiki/List_of_software-defined...

   Elektor SDR [38] Bare PCB and pre-built 150 kHz – 30 MHz ? No Soundcard ADC: 48, 96, and 192 kHz 0/1 USB Yes Yes Yes Elektor AVR SDR [39] Kit and pre-built up to 1 MHz in undersampling ? up to 15 kS/s 0/1 UART via RS2-232 converter or USB bridge Yes Yes Yes ELAD FDM-S1 [40] Pre-built 20 kHz – 30 MHz, up to 200 MHz in undersampling

5. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   [21]: 149 [18]: 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental penetration by a misplaced nail or screw. [21]: 149 Although the fittings are not cheap, they are reasonably durable (the rubber is typically neoprene or flexible PVC).

6. SMA connector - Wikipedia

   en.wikipedia.org/wiki/SMA_connector

   The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.

7. Plumbing - Wikipedia

   en.wikipedia.org/wiki/Plumbing

   In addition to lengths of pipe or tubing, pipe fittings such as valves, elbows, tees, and unions. are used in plumbing systems. [40] Pipe and fittings are held in place with pipe hangers and strapping. Plumbing fixtures are exchangeable devices that use water and can be connected to a building's plumbing system. They are considered to be ...