Search results
Results from the WOW.Com Content Network
Hop-by-hop is the fundamental characteristic of the IP Internet layer [1] and the OSI Network Layer. When a router interface is configured with an IP address and subnet mask, the interface becomes a host on that attached network. A directly connected network is a network that is directly attached to one of the router interfaces.
Networks are separated from each other by specialized hosts, called gateways or routers with specialized software support optimized for routing. IP forwarding algorithms in most routing software determine a route through a shortest path algorithm. In routers, packets arriving at an interface are examined for source and destination addressing ...
A forwarding information base (FIB), also known as a forwarding table or MAC table, is most commonly used in network bridging, routing, and similar functions to find the proper output network interface controller to which the input interface should forward a packet. It is a dynamic table that maps MAC addresses to ports.
When an interface has an address configured in a subnet, such as 192.0.2.1 in the 192.0.2.0/24 (i.e., subnet mask 255.255.255.0) subnet, and that interface is considered "up" by the router, the router thus has a directly connected route to 192.0.2.0/24. If a routing protocol offered another router's route to that same subnet, the routing table ...
The network layer provides the means of transferring variable-length network packets from a source to a destination host via one or more networks. Within the service layering semantics of the OSI (Open Systems Interconnection) network architecture, the network layer responds to service requests from the transport layer and issues service requests to the data link layer.
The payload of an IPv6 packet is typically a datagram or segment of the higher-level transport layer protocol, but may be data for an internet layer (e.g., ICMPv6) or link layer (e.g., OSPF) instead. IPv6 packets are typically transmitted over the link layer (i.e., over Ethernet or Wi-Fi ), which encapsulates each packet in a frame .
The forwarding decision is generally made using one of two processes: routing, which uses information encoded in a device's address to infer its location on the network, or bridging, which makes no assumptions about where addresses are located and depends heavily on broadcasting to locate unknown addresses.
Routing protocols, according to the OSI routing framework, are layer management protocols for the network layer, regardless of their transport mechanism: IS-IS runs on the data link layer (Layer 2) Open Shortest Path First (OSPF) is encapsulated in IP, but runs only on the IPv4 subnet, while the IPv6 version runs on the link using only link ...