Search results
Results from the WOW.Com Content Network
Match plate patterns are patterns with the top and bottom parts of the pattern, also known as the cope and drag portions, mounted on opposite sides of a board. This adaptation allows patterns to be quickly moulded out of the molding material.
The pattern is lifted from the sand, leaving a molding cavity. A passageway for metal to enter the mold, called a "gate", is then cut from the sprue hole to the void left by the pattern, and a runner is cut from the sand to allow metal to flow into the riser. The flask is then put back together, and metal can be poured into the mold.
The pattern is placed on the sand and another molding box segment is added. Additional sand is rammed over and around the pattern. Finally a cover is placed on the box and it is turned and unlatched, so that the halves of the mold may be parted and the pattern with its sprue and vent patterns removed.
Top plate—It is used to clamp the top half of the mold to the moving half of the molding machine and is usually made of mild steel. Cavity plate—The plate used to create a cavity (via a gap) that will be filled with the plastic material and form the plastic component. Usually made of mild steel.
Molding material: The material that is packed around the pattern and then the pattern is removed to leave the cavity where the casting material will be poured. Flask: The rigid wood or metal frame that holds the molding material. Cope: The top half of the pattern, flask, mold, or core. Drag: The bottom half of the pattern, flask, mold, or core.
Ceramic mold casting, also known ambiguously as ceramic molding, [1] is a group of metal casting processes that use ceramics as the mold material. It is a combination of plaster mold casting and investment casting. [2] [3] There are two types of ceramic mold casting: the Shaw process and the Unicast process. [4]
Evaporative-pattern casting is a type of casting process that uses a pattern made from a material that will evaporate when the molten metal is poured into the molding cavity. The most common evaporative-pattern material used is polystyrene foam. [1] The two major evaporative-pattern casting processes are: [1] Lost-foam casting; Full-mold casting
Lost-foam casting (LFC) is a type of evaporative-pattern casting process that is similar to investment casting except foam is used for the pattern instead of wax. This process takes advantage of the low boiling point of polymer foams to simplify the investment casting process by removing the need to melt the wax out of the mold.