Search results
Results from the WOW.Com Content Network
IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet. The standards are produced by the working group of the Institute of Electrical and Electronics Engineers (IEEE).
Examples of CPE types include modems, routers, gateways, set-top boxes, and VoIP-phones. TR-069 was first published in May 2004, with amendments in 2006, 2007, 2010, July 2011 (version 1.3), [ 1 ] and November 2013 (version 1.4 am5) [ 2 ] The Home Gateway Initiative (HGI), Digital Video Broadcasting Project (DVB) and WiMAX Forum have endorsed CWMP.
Router configuration rules may contain static routes. A static route minimally has a destination address, a prefix length or subnet mask, and a definition where to send packets for the route. That definition can refer to a local interface on the router, or a next-hop address that could be on the far end of a subnet to which the router is connected.
Such switches are commonly known as layer-3 switches or multilayer switches. [2] Switches for Ethernet are the most common form of network switch. The first MAC Bridge [3] [4] [5] was invented [6] in 1983 by Mark Kempf, an engineer in the Networking Advanced Development group of Digital Equipment Corporation. The first 2 port Bridge product ...
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Some devices with dual-band wireless network connectivity do not allow the user to select the 2.4 GHz or 5 GHz band (or even a particular radio or SSID) when using Wi-Fi Protected Setup, unless the wireless access point has separate WPS button for each band or radio; however, a number of later wireless routers with multiple frequency bands and ...
The link-state protocol is performed by every switching node in the network (i.e., nodes which are prepared to forward packets; in the Internet, these are called routers). [3] The basic concept of link-state routing is that every node constructs a map of the connectivity to the network in the form of a graph , showing which nodes are connected ...