Search results
Results from the WOW.Com Content Network
UA025A – 10 kV, 250 mA Argon-filled, half-wave rectifier with an E27 Edison screw lamp base and an anode screw top cap; UA5A – 11 kV, 5 A Half-wave mercury-vapor rectifier with a 2-pin base and an anode screw top cap; ZD1000F – Radiation-cooled power triode up to 60 MHz, 1 kW; ZD1XB – Air-cooled AF power triode up to 1.2 kW
The 866 is a mercury vapor half-wave rectifier intended for high-voltage applications. The voltage drop is approximately 15 volts up to 150 Hz. To avoid unwanted shorts the tube must be operated in a vertical position and the filament preheated for at least 30 seconds before applying the plate voltage.
In half-wave rectification of a single-phase supply, either the positive or negative half of the AC wave is passed, while the other half is blocked. Because only one half of the input waveform reaches the output, mean voltage is lower. Half-wave rectification requires a single diode in a single-phase supply, or three in a three-phase supply.
Rectifier circuits are often classified by the number of current pulses that flow to the DC side of the rectifier per cycle of AC input voltage. A single-phase half-wave rectifier is a one-pulse circuit and a single-phase full-wave rectifier is a two-pulse circuit. A three-phase half-wave rectifier is a three-pulse circuit and a three-phase ...
Mercury rectifier on display in the Beromünster AM transmitter in Switzerland, before being decommissioned.Three-phase full-wave rectifier with six anodes. A mercury-arc valve or mercury-vapor rectifier or (UK) mercury-arc rectifier [1] [2] is a type of electrical rectifier used for converting high-voltage or high-current alternating current (AC) into direct current (DC).
This is an accepted version of this page This is the latest accepted revision, reviewed on 8 October 2024. Circuit arrangement of four diodes Diode bridge Diode bridge in various packages Type Semiconductor Inventor Karol Pollak in 1895 Electronic symbol 2 alternating-current (AC) inputs converted into 2 direct-current (DC) outputs A hand-made diode bridge. The silver band on the diodes ...
Pulsed DC is commonly produced from AC (alternating current) by a half-wave rectifier or a full-wave rectifier. Full wave rectified ac is more commonly known as Rectified AC. PDC has some characteristics of both alternating current (AC) and direct current (DC) waveforms. The voltage of a DC wave is roughly constant, whereas the voltage of an AC ...
The characteristics and components of ripple depend on its source: there is single-phase half- and full-wave rectification, and three-phase half- and full-wave rectification. Rectification can be controlled (uses Silicon Controlled Rectifiers (SCRs)) or uncontrolled (uses diodes). There is in addition, active rectification which uses transistors.