Search results
Results from the WOW.Com Content Network
Typical live use of a multicore (thick cable on stage) Multicores usually create a link between the stage and sound desk, or live room and control room.When used in sound reinforcement, the multicore cable runs from the stage box or microphone splitter to the front-of-house sound desk, where it connects to a mixing console. [2]
These are typically used to carry microphone signals from one side of the stage to the other, or as an extension cable for a few channels on a larger stage box. [11] [12] The multicore cable attached to a drop box is often called a subsnake, although this may also refer to the entire assembly of drop box and multicore cable. [1]
A mult box is a device that allows a single audio source, such as a microphone, to be shared to multiple outputs for recording or broadcast. [1] A mult box is sometimes called a press box, but that term is usually reserved for the sports media's section of an arena. It may also be called a press mult box or press bridge. [2]
If you’re using the set-top box/cable receiver box, you’re paying $12.99 per month for single DVR service or $19.99 to $39.99 per month for multiple DVR service. Yearly cost: Cable box DVR ...
The new box costs $5 per month for 12 months or you can buy it outright for $60. If you’re keeping the box longer than that, it’s smarter to buy. If you’re keeping the box longer than that ...
Two pins are used for the mono headphone signal and two pins for the unbalanced microphone signal. The 4-pin XLR connector is also commonly used on amateur radio microphones, but transferring unbalanced audio instead, and using the 4th pin (with the common ground) for a push-to-talk (PTT) circuit activated by a button on the microphone.
Wrap-It Cable Clams $ at The Container Store. Wrap-It Cable Clams $ at Wrap-it. Wrap-It Cable Clams $ at Ace Hardware. This six-pack of cable clams are especially useful for wrapping up cords ...
A DI unit (direct input or direct inject) is an electronic device typically used in recording studios and in sound reinforcement systems to connect a high output impedance unbalanced output signal to a low-impedance, microphone level, balanced input, usually via an XLR connector and XLR cable.