Search results
Results from the WOW.Com Content Network
Length between perpendiculars (often abbreviated as p/p, p.p., pp, LPP, LBP or Length BPP) is the length of a ship along the summer load line from the forward surface of the stem, or main bow perpendicular member, to the after surface of the sternpost, or main stern perpendicular member. When there is no sternpost, the centerline axis of the ...
Length between perpendiculars – The distance between where the forward part cuts the waterline and the rudder post of the ship. Length Overall (LOA) – The maximum length of the ship between the ship's extreme points; important for berthing purposes. Length at Waterline (LWL) – The ship's length measured at the waterline.
The total number vary per the length of a ship. Frame numbers tell you where you are in relation to either the bow or the stern of the ship. [2] The frames support lengthwise members which run parallel to the keel, from the bow to the stern; these may variously be called stringers, strakes, or clamps. [3]
A stave bearing is a simple journal bearing where a shaft rotates in a bearing housing. Rather than the usual arrangement where the fixed part of the bearing surrounds most of the circumference of the shaft in one or two pieces, a stave bearing uses a large number of axial staves to support the shaft. A large housing is made with grooves ...
Vertical transom and stern of a modern cargo ship. In some boats and ships, a transom is the aft transverse surface of the hull that forms the stern of a vessel. Historically, they are a development from the canoe stern (or "double-ender") wherein which both bow and stern are pointed. Transoms add both strength and width to the stern.
Stern: the rear of a ship (opposite of "bow"). [1] Topside: the top portion of the outer surface of a ship on each side above the waterline. [1] Underdeck: a lower deck of a ship. [21] Yardarm: an end of a yard spar below a sail. Waterline: where the water surface meets the ship's hull. Weather: side or direction from which wind blows (same as ...
For maritime and aviation applications, the clock bearing is almost always a relative bearing; i.e., the angle stated or implied is angular distance from the longitudinal axis of the vessel or imaginary vessel to the bearing. However, if the 12:00 position is associated with a true bearing, then the observed position is also.
A vessel's length at the waterline (abbreviated to L.W.L) [1] is the length of a ship or boat at the level where it sits in the water (the waterline). The LWL will be shorter than the length of the boat overall (length overall or LOA) as most boats have bows and stern protrusions that make the LOA greater than the LWL. As a ship becomes more ...